Read Panasonic TX-28DK1F Service Manual online
HOW TO MOVE THE CHASSIS
INTO SERVICE POSITION
INTO SERVICE POSITION
1. Remove the bead clamper from the mains lead and
affix, using back cover screw, into top right-hand
cabinet rib (A), shown in Fig. 4.
cabinet rib (A), shown in Fig. 4.
2. Hold and lift the rear of the chassis and gently pull
the chassis toward you, as shown in Fig. 4.
3. Release the respective wiring clips and rotate the
chassis vertically through 90
°
, anti-clockwise.
4. Locate the base of the chassis frame into location
(C), shown in Fig. 5 / Fig. 7.
5. Clip the chassis frame onto the bead clamper, shown
in Fig. 5 / Fig. 6.
6. After servicing replace the bead clamper and ensure
all wiring is returned to its original position before
returning the receiver to the customer.
returning the receiver to the customer.
SERVICEPOSITION FÜR DAS CHASSIS
1. Entfernen Sie den Kabelbinder von der Netzleitung und
befestigen Sie ihn mit einer Rückwandschraube am Gehäuse
an der Position (A). (Abb. 4)
an der Position (A). (Abb. 4)
2. Das Chassis am hinteren Ende anheben und vorsichtig
herausziehen (Abb. 4).
3. Die Kabelhalter werden gelöst und das Chassis gegen den
Uhrzeigersinn um 90º gedreht.
4. Das untere Ende des Chassis wird in die Halterung (C)
gesteckt (Abb. 5 / Abb. 7).
5. Das obere Ende des Chassis wird in den Kabelbinder
eingehängt (Abb. 5 / Abb. 6).
6. Nach der Reparatur wird der Kabelbinder entfernt und alle
Kabelbäume auf die Originalposition in die Halterungen
eingesetzt.
eingesetzt.
5
Fig. 5.
Abb.5.
(C)
Fig. 6.
Abb.6.
Fig. 7.
Abb.7.
Fig. 4.
Abb.4.
(A)
Click on the first or last page to see other TX-28DK1F service manuals if exist.