TX-23LX60F, TX-23LX60P - Panasonic TV Service Manual (repair manual). Page 9

• 

Set the Bass to maximum position, set the Treble to minimum position then keep pressing the INDEX button on the
remote control and press the down button (-/v) on the TV set, this will place the TV set into the Service Mode 1.

• 

Press the RED / GREEN buttons to step up / down through the functions.

• 

Press the YELLOW / BLUE buttons to alter the function values, to alter White Rasters use +/- buttons

• 

Press the OK button after each adjustment has been made to store the required values.

• 

To exit the Service Mode, press the "N" button.

Note: All setting values are approximate

Sub-Contrast

Sub-Contrast

35

Receive a 80% white level Philips Pattern with correct

sound system (B/G, D/K) via aerial input. For Sub-

Contrast alignment press "Blue" button, wait until the

figure colour is changed from red to black colour.

Press the OK.

DVCO

DVCO

0

Receive a 80% white level Philips Pattern via aerial

input.  For DVCO alignment press "Blue" button, wait

until the figure colour is changed from red to black

colour. Press the OK.

Highlight

Lowlight

 For correct setting see White Balance Adjustment

Sub-Brightness

Sub-Brightness

0

Optimum setting.

• 

Remote Control

• 

LCD WB meter (Minolta CA-210 or equivalent)

• 

Switch on the TV Set. Enter Service1. Step down to Highlight line and keep the aging time more than 20 minutes.

• 

After aging time above set White Raster No.12 for Highlight and No.4 for Lowlight

Press the OK button

to store.

• 

Put Minolta Sensor to the center of the LCD Panel with 25mm gap between Minolta Sensor and LCD Panel. Adjust "x"
and "y" values by changing Red and Blue values.

• 

Press OK button to store setting.

High

12

0305

0300

0313

Low

4

0018

0023

0003

High

12

Low

4

Item

Value

x

0,275

±0,005

Highlight

y

0,275

±0,005

x

0,275

±0,005

Lowlight

y

0,285

±0,005