TX-15PM30T, TC-21X3, TX-21X3T - Panasonic TV Service Manual (repair manual). Page 8

Read Panasonic TX-15PM30T / TC-21X3 / TX-21X3T Service Manual online

Adjustment Procedure
Item / Preparation
Adjustment Procedure
+B Voltage
1. Operate the TV set.
Confirm the DC voltage at the indicated test points,
as follow : 
2. Set control as follow :
TPA 12 : 141.2 +- 0.8V
TPA 21 : 215 +- 15V
    Brightness ..... minimum
TPA 11 : 8 +- 1V
    Contrast ........ minimum
TPA 10 : 5 +- 1V
RF AGC
1. Receive a colour bar signal at an
1. Select “RF AGC” indication in CHK 2, on Screen 
    RF level of 75dBU with 75         
    by remote control at factory mode.
    loaded.
2. Connect digital multimeter to RF AGC
2. Set RF AGC by using remote control volume (+) 
    at Tuner.
    or volume (-) button until voltage AGC at Tuner
    reach 2.7 +- 0.1V.
3. Increase RF signal strenght by 2dB, confirm 
    AGC at Tuner voltage drop.
High Voltage
1. Receive the crosshatch pattern.
1. Connect a DC voltage meter to TPA 12 
     and confirm the +B voltage is 141.2 +- 0.8V.
2. Set to 0 Beam .
2. Connect a high frequency voltmeter to heater and
    Screen VR ..... minimum
    confirm that voltage reads 6.0+- 0.24 (VRMS).
    Contrast ....... minimum
3. Normalize the brightness and contrast.
   
       
Item / Preparation
Adjustment Produre
Connect a short jumper between TPA 10
1. Adjust Sub-Tint so that No.2,3 and 4 becomes
and TPA 20.
    level waveform is similiar to Fig. 10.
Press Main Menu and Set system to 
2. Confirm phase at Tint is changes more than
Use AV-NTSC (3.58MHz).
    +/- 30 by Tint control.
DYNAMIC ....... Normal
3. Confirm that colour level is maximum when 
     colour DAC is adjusted to maximum position.
     
Note:Use Remote control only when adjusting user mode   
  
  to Sub-Tint.
 
0.5a
a
7  8  9  10
1  2  3   4  5    6
Fig. 10
Page of 28
Display

Click on the first or last page to see other TX-15PM30T / TC-21X3 / TX-21X3T service manuals if exist.