Read Panasonic TH-98SQ1W (serv.man2) Service Manual online
ADJ-17
SECTION 3 ADJUSTMENTS
<98/86SQ1>
2.3. Cloning procedure (Service Mode)
1. Insert USB Memory to the USB interface.
2. Display the CAT mode (Refer to Section 1 - 3.1.)
3. Press the [SETUP] button to display the setup menu on the screen. Select [OSD LANGUAGE] menu with [pq] buttons
and press and hold the [ENTER] button for more than 3 seconds.
The below window will appear. (USB Data cloning is gray out when USB Memory is not inserted.)
4. Select [USB Data Cloning] menu with [pq] buttons and press ENTER button. The below window will appear.
5. Select [Board Replace] menu with [pq] buttons and press enter button. The below window will appear.
5.1. Display→USB Memory
Select [Display→USB Memory] and then click [Yes] to start cloning.
After finishing the copying, the window below appear.
5.2. USB Memory→Display
Select [USB Memory→Display] and then click [Yes] to start cloning.
After finishing the copying, the window below appear.
5.3. After data copy has finished, remove the USB memory device from the USB terminal.
Disconnect the power cable of the display and turn the power off. And then, reconnect the power cable and turn
the power on again.
The copied content is applied to the Display.
Options
Display information
Software licenses
Cloning password
USB data cloning
LAN data cloning
Output log data
Shipping
Select Copy Type
Display → USB Memory
USB Memory → Display
Select Copy Contents
User Menu Data
Board Replace
Data to USB memory
Tha data will be overwritten when any data exists or originally.
Are you OK to write the data?
Yes
No
Data copy finished.
Data from USB memory
Do you copy the data?
Yes
No
Click on the first or last page to see other TH-98SQ1W (serv.man2) service manuals if exist.