Read Panasonic TC-51P100G / TC-51P100H Service Manual online
0.7W (Stand-by condition)
32.5 MHz (B, G)/33.5 MHz (M)
33.75 MHz (SECAM)/34.42 MHz (NTSC)
NICAM D, A2 (German)
“R6” Battery x 2
Mass and dimensions shown are approximate.
If a short circuit is found, replace all parts which
have been overheated or damaged by the short
papers, shields, and isolation R-C combinations,
are properly installed.
Monitor without the rear cover involves the danger
of a shock hazard from the power supply. Servicing
should not be attempted by anyone who is not
thoroughly familiar with the precautions necessary
when working on high voltage equipment. Always
discharge the anode of the projection tube to the
Projection Monitor chassis before handling the
exposed to shock hazards.
3. Measure the resistance value, with an ohmmeter,
metallic cabinet part on the projection monitor,
such as screw heads, connectors, control shafts,
etc. When the exposed metallic part has a return
path to the chassis, the reading should be between
path to the chassis, the reading must be
and an earth such as a water pipe.
specified, there is a possibility of a shock hazard,
and the projection monitor should be repaired and
rechecked before it is returned to the customer.
( Earth )