Read Panasonic TC-42P1 / TC-42P1F Service Manual online
Weight and Dimensions shown are approximate.
Stand-by condition: 1.7W
Power off condition: 0.7W
42-inch, 16:9 aspect ratio
920mm(W) x 518mm(H) x 1056mm(diagonal)
No. of pixels
408,960(852 (W) x 480 (H)) [2,556 x 480 dots]
signals cannot be displayed.)
Scanning format: 525i, 525p, 625i, 625p, 1080i, 1080p
PC signals: VGA, S-VGA (compressed), Horizontal scanning fre-
RGB (Sync on G, Separate HD/VD)
VIDEO OUT (BNC) 1.0V p-p (75
If a short circuit is found, replace all parts which
have been overheated or damaged by the short
papers, shields, and isolation R-C combinations,
are properly installed.
from the power supply. Servicing should not be
attempted by anyone who is not thoroughly familiar
with the precautions necessary when working on
high voltage equipment. Always discharge the
anode of the projection tube to the Projection Mon-
itor chassis before handling the tube.
exposed to shock hazards.
3. Measure the resistance value, with an ohmmeter,
metallic cabinet part on the projection monitor,
such as screw heads, connectors, control shafts,
etc. When the exposed metallic part has a return
path to the chassis, the reading should be between
4 MW and 20 MW.
When the exposed metal does not have a return
path to the chassis, the reading must be •.
and an earth such as a water pipe.
specified, there is a possibility of a shock hazard,
and the projection monitor should be repaired and
rechecked before it is returned to the customer.
( Earth )