Read Panasonic TC-29EG20TS Service Manual online
4.1.1. +B Voltage
Item / preparation
1. Operate the TV set.
2. Set control as follows :
Brightness ........... minimum
Contrast ............... minimum
Adjustment procedure
1. Confirm the DC voltage at the indicated test points, as
follows :
TPA 15 : 3.35 ± 0.2V
TPA 16 : 141 ± 2V
TPA 17 : 8.2 ± 0.3V
TPA 18 : 1.9 ± 0.2V
TPA 19 : 5.2 ± 0.2V
TPA 20 : 220 ± 15V
1. Set Bright and Contrast controls to their maximum
positions.
2. Operate the TV set over 60 minutes.
3. Full degauss the picture tube by using an external
degaussing coil. By rotating R-B static convergence
magnet.
magnet.
4.1.2. High Voltage
Item / preparation
1. Receive the crosshatch pattern.
2. Set to 0 Beam.
Screen VR .......... minimum
Contrast .............. minimum
Adjustment procedure
1. Connect a DC voltage meter to D866 and confirm the +B
voltage is 141.0 ± 2V.
2. Connect a high frequency voltmeter to heater and confirm
that voltage reads 6.3 ± 0.28 (VRMS).
3. Normalize the brightness and contrast.
4.1.3. NTSC TINT COLOUR
Item / preparation
1. Connect oscilloscope probe to TPL1 (R OUT) with 10k
Ω
series resistor.
2. Press Main Menu and set system to use AV-NTSC (3.58
MHz).
DYNAMIC ................... Normal
Channel CLR Set ..... STD
Adjustment procedure
1. Adjust Sub-Tint so that No. 2, 3 and 4 becomes level
waveform is similar to Fig. 3.
2. Confirm phase at Tint is changes more than ± 15 by Tint
control.
3. Confirm that colour level is maximum when colour DAC is
adjusted to maximum position.
Note: Use remote control only when adjusting user mode to
Sub-Tint.
Sub-Tint.
4. Apply a crosshatch pattern signal and adjust roughly the
static convergence magnets.
5. Apply a green pattern signal.
6. Loosen a clamp screw for the Deflection Yoke and move
the Deflection Yoke as close to the purity magnet as
possible.
possible.
4 Adjustment Procedure
4.1. Adjustment Procedure
4.2. COLOUR PURITY
7
TC-29EG20TS
Click on the first or last page to see other TC-29EG20TS service manuals if exist.