Read Panasonic TC-15LT1 Service Manual online
6.4.
Component input video level adjustment
6.4.1.
Preparation
Connect component signal generator to D2 terminal.
* This adjustment can be performed with the component signals (Y, CB and CR) produced by DVD equipment.
Video adjustment
PICTURE ADJUST: NORMAL
PICTURE MENU: DYNAMIC
LCD AI : OFF
Enter into the service adjustment mode.
6.4.2.
Input signal
100% color bar signal
6.4.3.
Measuring equipment and connection point
Oscilloscope
Y GAIN: TS7(+) - TS10(-)
B-Y: TS8(+) - TS10(-)
R-Y: TS9(+) - TS10(-)
6.4.4.
Adjustment method and value
1. Select the main adjustment and then YGAIN.
2. Using [VOL+] and [VOL-] buttons of the remote control unit, adjust the MAX to become D4.
3. Measure the waveform amplitude (from pedestal to white level) at TS7. (Reference: 0.73 Vp-p)
4. Select the main adjustment and then B-Y.
5. Using [VOL+] and [VOL-] buttons of the remote control unit, adjust the amplitude at TS8 to become identical to the value
measured in 3.
6. Select the main adjustment and then R-Y.
7. Using [VOL+] and [VOL-] buttons of the remote control unit, adjust the amplitude at TS9 to become identical to the value
measured in 3.
6.5.
Video input video level adjustment
6.5.1.
Preparation
Connect NTSC signal generator to video input terminal with connector cable.
Video adjustment
PICTURE ADJUST: NORMAL
PICTURE MENU: DYNAMIC
LCD AI : OFF
Enter into the service adjustment mode.
19
TC-15LT1
Click on the first or last page to see other TC-15LT1 service manuals if exist.