TC-14D2Q - Panasonic TV Service Manual (repair manual). Page 9

Read Panasonic TC-14D2Q Service Manual online

Colour Purity
 1. Set the Brightness and Contrast controls to their maximum
positions.
 2. Operate the TV set for 60 minutes.
 3. Fully degauss the picture tube by using an external
degaussing coil.
 4. Apply a crosshatch pattern signal and adjust the static
convergence magnets to the approximately correct position.
 5. Receive a black and white signal.
 6. Set the control as follows:
Red................minimum
Green.............minimum
Blue.................minimum
Press the Shipping button on the remote control twice to
select CRT Adjustment Mode to select low light.
 7. Loosen the clamp screw for the deflection yoke A in Fig. 10
and move the deflection yoke as close to the purity magnet
as possible.
 8. Adjust the purity magnetic rings so that a vertical green field
is obtained at the centre of the screen.
Fig. 6
 9. Slowly push the deflection yoke and set it where a uniform
green field is obtained.
Fig. 7
 10. Re-adjust the Low Light controls to their correct settings
and make sure that a uniform white field is obtained.
 11. Tighten the clamp screw A in Fig. 10.
Convergence
 1. Apply a crosshatch pattern signal and Normalize Contrast
control to the maximum positions.
 2. Adjust Brightness until the grey position of the crosshatch
pattern just becomes black.
 3. Adjust the Red and Blue line at the centre of the screen by
rotating the R-B static.
Fig. 8
 4. Adjust Red and Blue with Green line at centre of the screen
by rotating (RB) -G static convergence magnetic rings.
 5. Lock convergence magnets with silicone sealer.
 6. Remove the DY wedges and slightly tilt the deflection yoke
vertically and horizontally to obtain the good overall
convergence.
Fig. 9
 7. Fix the deflection yoke by reinserting the DY wedges. Refer
to Fig. 10.
 8. If purity error is found, repeat “Colour Purity” adjustment.
Before Colour Purity, Convergence and White Balance adjustment are attempted,
V. Height, H. Centre and Focus adjustments must be completed.
9
TC-14D2Q
Page of 23
Display

Click on the first or last page to see other TC-14D2Q service manuals if exist.