Read Panasonic KX-TG6551RUM / KX-TGA650RUM / KX-TGA651RUM Service Manual online
14
KX-TG6551RUM/KX-TGA650RUM/KX-TGA651RUM
4.3.6.
Transmitter/Receiver
• Audio Circuits and DTMF tone signal circuits.
Base Unit and Handset mainly consist of RF Module and DECT BBIC.
Base Unit and Handset transmit/receive voice signal and data signal through the antenna on carrier frequency.
Base Unit and Handset transmit/receive voice signal and data signal through the antenna on carrier frequency.
Signal Path:
*Refer to Signal Route (P.18).
4.3.6.1.
Transmitter Block
The voice signal input from the TEL LINE interface goes to through DECT BBIC (IC501) as shown in Block Diagram (Base
Unit_Main) (P.7)
The voice signal passes through the analog part of IC501 where it is amplified and converted to a digital audio stream signal.
The burst switch controller processes this stream performing encryption and scrambling, adding the various other fields to
produce the GAP (Generic Access Profile) standard DECT frame, assigning to a time slot and channel etc.
In IC501, the carrier frequency is changing, and frequency modulated RF signal is generated. RF signal is amplified, and
radiated from antenna. Handset detects the voice signal or data signal in the circuit same as the following explanation of
Receiver Block.
Unit_Main) (P.7)
The voice signal passes through the analog part of IC501 where it is amplified and converted to a digital audio stream signal.
The burst switch controller processes this stream performing encryption and scrambling, adding the various other fields to
produce the GAP (Generic Access Profile) standard DECT frame, assigning to a time slot and channel etc.
In IC501, the carrier frequency is changing, and frequency modulated RF signal is generated. RF signal is amplified, and
radiated from antenna. Handset detects the voice signal or data signal in the circuit same as the following explanation of
Receiver Block.
4.3.6.2.
Receiver Block
The signal of 1900 MHz band (1881.792 MHz ~ 1897.344 MHz) which is input from antenna is input to IC501 as shown in Block
Diagram (Base Unit_Main) (P.7).
In IC501, the signal of 1900 MHz band is downconverted to 864 kHz signal and demodulated, as GAP (Generic Access Profile)
standard DECT frames. It passes through the decoding section burst switch controller where it separates out the frame
information and performs de-encryption and de-scrambling as required. It then goes to the DSP section where it is turned back
into analog audio. This is amplified by the analog front end, and goes to the TEL LINE Interface.
Diagram (Base Unit_Main) (P.7).
In IC501, the signal of 1900 MHz band is downconverted to 864 kHz signal and demodulated, as GAP (Generic Access Profile)
standard DECT frames. It passes through the decoding section burst switch controller where it separates out the frame
information and performs de-encryption and de-scrambling as required. It then goes to the DSP section where it is turned back
into analog audio. This is amplified by the analog front end, and goes to the TEL LINE Interface.
4.3.7.
Pulse Dialling
During pulse dialling the hookswitch (Q3, Q4) is used to generate the pulses using the HOOK control signal, which is set high
during pulses. To force the line impedance low during the “pause” intervals between dial pulses, the PULSE_DIAL signal turns
on Q2.
during pulses. To force the line impedance low during the “pause” intervals between dial pulses, the PULSE_DIAL signal turns
on Q2.
Click on the first or last page to see other KX-TG6551RUM / KX-TGA650RUM / KX-TGA651RUM service manuals if exist.