Read Panasonic KX-TG6461CAT / KX-TGA641RUT Service Manual online
13
KX-TG6461CAT/KX-TGA641RUT
4.4.
Circuit Operation (Cordless Handset)
4.4.1.
Outline
Cordless Handset consists of the following ICs as shown in Block Diagram (Cordless Handset) (P.12).
• DECT BBIC (Base Band IC): IC1
- All data signals (forming/analyzing ACK or CMD signal)
- All interfaces (ex: Key, Detector Circuit, Charge, DC/DC Converter, EEPROM, LCD, RF Power Amp.)
- PLL Oscillator
- Detector
- Compress/Expander
- Reception
- All interfaces (ex: Key, Detector Circuit, Charge, DC/DC Converter, EEPROM, LCD, RF Power Amp.)
- PLL Oscillator
- Detector
- Compress/Expander
- Reception
• RF Power Amp: IC801
- Amplifier for transmission
• EEPROM: IC3
- Temporary operating parameters (for RF, etc.)
4.4.2.
Power Supply Circuit/Reset Circuit
Circuit Operation:
When power on the Cordless Handset, the voltage is as follows;
BATTERY(2.2 V ~ 2.6 V: BATT+)
BATTERY(2.2 V ~ 2.6 V: BATT+)
→ F1 → Q2 (1.8 V), IC1-43pin (2.5V)
The Reset signal generates IC1 (61 pin) and 1.8 V.
4.4.3.
Charge Circuit
Circuit Operation:
When charging the Cordless Handset on the Charger Unit, the charge current is as follows;
DC+(6.5 V)
DC+(6.5 V)
→ F1 → R1 → CHARGE+(Charger) → CHARGE+(Cordless Handset) → L4 → Q4 → D7→ F1 → BATTERY+... Bat-
tery...
BATTERY-
BATTERY-
→ L8 → R45 → GND → L5 → CHARGE-(Cordless Handset)→ CHARGE-(Charger) → GND → DC-(GND)
In this way, the BBIC on Cordless Handset detects the fact that the battery is charged.
The charge current is controlled by switching Q9 of Cordless Handset.
The charge current is controlled by switching Q9 of Cordless Handset.
4.4.4.
Battery Low/Power Down Detector
Circuit Operation:
“Battery Low” and “Power Down” are detected by BBIC which check the voltage from battery.
The detected voltage is as follows;
The detected voltage is as follows;
• Battery Low
Battery voltage: V(Batt) 2.25 V ± 50 mV
The BBIC detects this level and "
" starts flashing.
• Power Down
Battery voltage: V(Batt) 2.0 V ± 50 mV
The BBIC detects this level and power down.
The BBIC detects this level and power down.
4.4.5.
Speakerphone
The hands-free loudspeaker at SP+ and SP- is used to generate the ring alarm.
Click on the first or last page to see other KX-TG6461CAT / KX-TGA641RUT service manuals if exist.