KX-TG2511UAM, KX-TG2511UAN, KX-TG2511UAS, KX-TG2511UAT, KX-TG2512UAM, KX-TG2512UAT, KX-TGA250RUM, KX-TGA250RUN, KX-TGA250RUS, KX-TGA250RUT (serv.man5) - Panasonic Telephone Service Manual Supplement (repair manual). Page 10

10

Base Unit consists of the following ICs as shown in Block Diagram (Base Unit) (P.9).

• DECT BBIC (Base Band IC): IC501

- Handling all the audio, signal and data processing needed in a DECT base unit
- Controlling the DECT specific physical layer and radio section (Burst Module Controller section)
- ADPCM code filter for speech encoding and speech decoding (DSP section)
- Echo-cancellation and Echo-suppression (DSP section)
- Any tones (tone, sidetone, ringing tone, etc.) generation (DSP section)
- DTMF receiver (DSP section)
- Clock Generation for RF Module
- ADC, DAC, timer, and power control circuitry
- PLL Oscillator
- Detector 
- Compress/Expander
- First Mixer
- All interfaces (ex: QSPI FLASH MEMORY, EEPROM, LED, Analog Front End, etc.)
- Integrated 1.9GHz PA for DECT

• EEPROM: IC611

- Temporary operating parameters (for RF, etc.)

• Additionally,

- Power Supply Circuit (+3.0 V output)
- Crystal Circuit (13.824 MHz)
- Charge Circuit

- Telephone Line Interface Circuit