Read Panasonic KX-TCD725RUM Service Manual online
6 CIRCUIT OPERATION (BASE UNIT)
BLOCK DIAGRAM BASEBAND SECTION AND LINE INTERFACE (BASE UNIT)
6.1.
THE BASE-BAND SECTION
6.1.1.
INTRODUCTION (SEE Fig. 17)
The base-band section consists ofa base-band integrated circuit (BBIC), a Flash PROM, an EEPROM and Flash SERIAL DAA
ROM.
ROM.
6.1.2.
THE BASE-BAND INTEGRATED CIRCUIT (BBIC)
The PMB5737 (IC6) is a CMOS device designed to handle all the audio, signal and data processing needed in a DECT base
unit. It contains a "burst mode controller" which takes care ofDECT specific physical layer and radio section control. It also
contains an ADPCM codec filter used for speech encoding and decoding in the DSP section, a general purpose microcontroller,
various other ADC´s, DAC´s, timers and power control circuitry.
unit. It contains a "burst mode controller" which takes care ofDECT specific physical layer and radio section control. It also
contains an ADPCM codec filter used for speech encoding and decoding in the DSP section, a general purpose microcontroller,
various other ADC´s, DAC´s, timers and power control circuitry.
The BBIC interfaces to its external PROM (IC5) via a data/address/control bus. It connects to the EEPROM via a serial
interface, and a second serial interface is used during manufacture and service to connect to an external computer.
interface, and a second serial interface is used during manufacture and service to connect to an external computer.
It connects to Serial Flash ROM via serial interface.
14
KX-TCD725RUM
Click on the first or last page to see other KX-TCD725RUM service manuals if exist.