Read Panasonic KX-TCD556RUT / KX-TCD556RUV / KX-TCA151RUT / KX-TCA151RUV Service Manual online
28 EEPROM LAYOUT (HANDSET)
28.1. Scope
The purpose of this section is to describe the layout of the EEPROM (IC10) for the KX-TCA151 Handset.
The EEPROM contains hardware, software, and user specific parameters. Some parameters are set during production of the
handset e.g. crystal oscillator adjustment at 0057, some are set by the user when configuring the handset e.g. ringer volume
at 00A1, and some during normal use of the phone e.g. redial memory at 1EF6..1F77.
handset e.g. crystal oscillator adjustment at 0057, some are set by the user when configuring the handset e.g. ringer volume
at 00A1, and some during normal use of the phone e.g. redial memory at 1EF6..1F77.
28.2. Introduction
The handset uses a 64k bit serial EEPROM (IC10) for storing volatile parameters. All parameters are set up before the handset
the factory. Some of these are vital for the operation of the hardware so a set of default parameters is programmed before the
actual hardware fine-tuning can be initiated. This document lists all default settings with a short description.
the factory. Some of these are vital for the operation of the hardware so a set of default parameters is programmed before the
actual hardware fine-tuning can be initiated. This document lists all default settings with a short description.
This document lists all default parameters with a short description.
In the tables below values in a range that are similar are not repeated; i.e. Address 00 to 01 contains the value 00 simply means
that the value 00 is repeated in all addresses in the range.
that the value 00 is repeated in all addresses in the range.
Initial Type
Description
F
The data initialized by only F command
0
The data initialized by F and 0 command
1
The data initialized by F, 0 and 1 command
2
The data initialized by all command (F,0,1,2)
Country Setting
Description
x
Default - no specific country setting, so revert to default value.
28.3. EEPROM contents
28.3.1.
General Setup
Address
Initial
Type
Name
Description
Default value
Country
Setting
52
F
EEP_Ipei
International Portable Part Equipment Identities.
A concatenation of an EMC and a unique 20 bit Serial
Number.
A concatenation of an EMC and a unique 20 bit Serial
Number.
0x00, 0x00,
0x00, 0x00,
0x00, 0x00,
0x00
x
57
F
EEP_FreqTrim_L
Setting value of FREQ_TRIM_REG
0x75
x
58
F
EEP_BandGap
Setting value of BandGap REG
0x08
x
6B
1
EEP_LowQualityLevel
Signal quality level at which handover is initiated.
(CRC error count)
(CRC error count)
0x10
0x20
74
1
EEP_RxMuteSyncError
Continuous SYNC error times for the Rx Mute.
(0-0xFF:Error times)
(0-0xFF:Error times)
0x0A
0x02
131
0
EEP_HandsetNumber
Handset Number each Subscription.
(wordx4subs)
(wordx4subs)
0xFF, 0xFF,
0xFF, 0xFF,
0xFF, 0xFF,
0xFF, 0xFF,
0xFF, 0xFF,
0xFF, 0xFF
x
139
0
EEP_Subscription0
GAP Subscription Data. Storage for 4 subscriptions each
with 53bytes.
<Subscription>
12E: SUB_boAssignedIPUI
12F: SUB_abIPUI[14]
13D: SUB_abPARK[5]
142: SUB_abSARI[4]
146: SUB_bPLI
147: SUB_bLAL
148: SUB_abARIplusRPN[5]
14D: SUB_boZAP
14E: SUB_bZAP
14F: SUB_boServiceClass
150: SUB_bServiceClass
151: AK_boUAKavailable
152: AK_boUAKproven
153: AK_boUAK_or_AC [16]
with 53bytes.
<Subscription>
12E: SUB_boAssignedIPUI
12F: SUB_abIPUI[14]
13D: SUB_abPARK[5]
142: SUB_abSARI[4]
146: SUB_bPLI
147: SUB_bLAL
148: SUB_abARIplusRPN[5]
14D: SUB_boZAP
14E: SUB_bZAP
14F: SUB_boServiceClass
150: SUB_bServiceClass
151: AK_boUAKavailable
152: AK_boUAKproven
153: AK_boUAK_or_AC [16]
All 0x00
x
1EBE
2
EEP_HSPinCode
Handset Pin: 4 BCD Digits
0x00, 0x00
x
79
KX-TCD556RUT / KX-TCD556R UV / KX-TCA151RUT / KX-TCA151RUV
Click on the first or last page to see other KX-TCD556RUT / KX-TCD556RUV / KX-TCA151RUT / KX-TCA151RUV service manuals if exist.