Read Panasonic KX-TCD500RUM / KX-TCA150RUM / KX-TCD500RUT / KX-TCA150RUT / KX-TCD500RUV / KX-TCA150RUV Service Manual online
4.3. Battery Information
After your Panasonic battery is fully charged:
Ni-MH Batteries (typical 700 mAh)
Operation
Operating Time
While in use (TALK)
10 hrs approx.
While not in use (Standby)
120 hrs approx.
Ni-Cd Batteries (typical 250 mAh)
Operation
Operating Time
While in use (TALK)
4 hrs approx.
While not in use (Standby)
40 hrs approx.
·
Times indicated are for peak performance.
·
The battery operating time may be shortened depending on usage conditions and ambient temperature.
·
Clean the charge contacts of the handset and the base unit with a soft, dry cloth. Clean if the unit is subject to grease,
dust or high humidity.
Otherwise the battery may not charge properly.
dust or high humidity.
Otherwise the battery may not charge properly.
·
The batteries cannot be overcharged unless they are repeatedly removed and replaced.
·
For maximum battery life, it is recommended that the handset not be recharged until the battery icon flashes
.
4.4. Replacing the Batteries
If the
icon flashes after a few telephone calls even when the handset batteries have been fully charged, both batteries
must be replaced.
·
Charge new batteries for approximately 7 hours before initial use.
(The telephone line cord must not be connected to the telephone socket at this time).
(The telephone line cord must not be connected to the telephone socket at this time).
·
When replacing the batteries, be sure to set up the battery type even if you install the same type of batteries to
initialise battery remaining memory of your handset.
initialise battery remaining memory of your handset.
·
The factory preset is
.
·
To exit the operation, press
any time.
·
Do not use non-rechargeable batteries. If non-rechargeable batteries are fitted and start charging, it may cause the leakage
of the battery electrolyte.
of the battery electrolyte.
·
Press the notch on the cover firmly and slide it as indicated by the arrow. Replace both batteries and close the cover then
charge the handset for about 7 hours.
charge the handset for about 7 hours.
Please order Panasonic P03P(Ni-MH) or P03H(Ni-Cd) batteries.
Note for Service:
Note for Service:
·
When Ni-Cd batteies are littled with the
setting in
,
icon might disappear and stop charging
even if the handset is on the cradle for avoiding overcharge.
9
KX-TCD500RUM / KX-TCA150RUM / KX-TCD500RUT / KX-TCA150RUT / KX-TCD500RUV / KX-TCA150RUV
Click on the first or last page to see other KX-TCD500RUM / KX-TCA150RUM / KX-TCD500RUT / KX-TCA150RUT / KX-TCD500RUV / KX-TCA150RUV service manuals if exist.