AW-RP655L - Panasonic Provideo Service Manual (repair manual). Page 2

- 

 

- 2 -

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This service information is designed for experienced repair technicians only and is not designed for use by the general public. It does not 
contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.  Products powered 
by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service or repair the product or 
products dealt with in this service information by anyone else could result in serious injury or death.

 

DC 10.8 V to DC 16 V

Power consumption:  9.0 W

Ambient operating temperature
 

–10˚C to +50˚C

Storage temperature
 

–20˚C to +60˚C

Ambient operating humidity
 

30% to 90% (no condensation)

Weight
 3.5 

kg

Dimensions (Wx Hx D)
 420x 52x 220 

mm

Finish
 

AV ivory paint (colour resembling Munsell 7.9Y 6.8/0.8)

Pan/tilt heads supported
 

 AW-PH300, AW-PH300A, AW-PH350, AW-PH360,  
AW-PH500, AW-PH600, AW-PH650

Cameras supported
 

 AW-E300, AW-E300A, AW-E600, AW-E800, AW-E800A, 
AW-E350, AW-E650, AW-E655, AW-E750, AW-E860

DC 12V IN socket
 XLR, 

4-pin

GND
 

Connect this to ground for use.

MONITOR SELECT connector
 

 RJ45 
Connecting cable: 
10BASE-T straight cables (UTP category 5),  
max. 50 meters

TO CONTROL PANEL [IN/OUT] connectors
 

 RJ45 (1 each) 
Connecting cable: 
10BASE-T straight cables (UTP category 5),  
max. 1,000 meters 
When more than one additional panel is to be connected, 
make sure that the total length of all the cables does not 
exceed 1,000 meters.

TALLY/INCOM
 D-SUB, 

15-pin

REMOTE/SERVICE
 RS-232C

TO PAN/TILT HEAD [1/EXT, 2 to 5] connectors
 

 RJ45 x 5, control signal output for pan/tilt heads 
Connecting cable: 
10BASE-T straight cables (UTP category 5),  
max. 1,000 meters

INCOM
 XLR, 

4-pin

TERMINATION switch
 

 Termination setting for communication line with control 
panel

ID switch
 

Operations mode (MAIN, 1, 2) setting.

REMOTE/SERVICE switch
 

Maintenance switch. Set in the “N” position during use.

Weight and dimensions shown are approximate.
Specifications are subject to change without notice.

 indicates safety information.