PT-VW345NZ, PT-VW345NZD, PT-VX415NZ, PT-VX415NZD - Panasonic Projector Service Manual (repair manual). Page 8

Read Panasonic PT-VW345NZ / PT-VW345NZD / PT-VX415NZ / PT-VX415NZD Service Manual online

INF-2
SECTION 1 SERVICE INFORMATION
1. The name of each part
1.1 Projector body
Zoom ring (Back)
Adjust the zoom.
Control Panel and Indicators (
Æ
 
page 27)
Lamp cover (
Æ
 
page 118)
The lamp unit is located inside.
Projection Lens 
Attention
Do not drop the remote control.
 
f
Avoid contact with liquids.
 
f
Do not attempt to modify or disassemble the remote control.
 
f
Please observe the following contents that are described on  
 
f
the back of the remote control unit (see the right picture). 
1. Do not use a new battery together with an old battery. 
2. Do not use unspecified batteries. 
3. Make sure the polarities (+ and -) are correct when inserting the batteries.
In addition, please read the contents that are related to batteries in the "Read this first!".
 
f
Note
The remote control can be used within a distance of about 7 m (22.97') if pointed directly at the remote control signal 
 
f
receiver. The remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control 
range may be reduced.
If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not 
 
f
operate correctly.
You can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to 
 
f
the loss of light caused by the properties of the screen.
When the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become 
 
f
inoperative. Set the projector as far from the luminous source as possible.
Projector body
WARNING
Keep your hands and other objects away from the air 
exhaust port.
Keep your hand and face away.
 
f
Do not insert your finger.
 
f
Keep heat-sensitive articles away.
 
f
Heated air from the air exhaust port can cause burns or 
external damage.
Focus ring (Front)
Adjust the focus.
Remote control signal receiver/Camera
 
Air exhaust port
Speaker
<AC IN> terminal
 
Connect the supplied power cord.
Rear terminals (
10 
Æ
 
page 28)
Air intake port / Air filter cover (
11 
Æ
 
page 116) 
The air filter unit is inside.
Adjustable feet
12 
Adjust the projection angle.
Security Chain Hook 
13 
Attaches a burglar prevention cable, etc.
Attention
Do not block the ventilation ports (intake and exhaust) of the projector.
 
f
1
2
3
4
6
7
8
9
10
11
12
5
13
1. 请勿把旧电池和新电池一起使用。
2. 请勿使用不合规格的电池。
3. 确保电池安装正确。
原产地:中国
1.Do not use old battery with new one.
2.Do not use batteries other than the
   type specified.
3.Be sure the batteries are inserted properly.
Made in China
26 - ENGLISH
Chapter 1   Preparation - About your projector
Some of the pages on this section are excerpted from the owner's 
manual, thus the reference page numbers on pages indicate those 
for owner's manual .
Page of 127
Display

Click on the first or last page to see other PT-VW345NZ / PT-VW345NZD / PT-VX415NZ / PT-VX415NZD service manuals if exist.