Read Panasonic PT-TW350 / PT-TX410 / PT-TX320 (serv.man3) Service Manual online
ADJ-10
SECTION 3 ADJUSTMENTS
<TW350/TX410/TX320>
4. Select the model name and destination from each pull down menu button, and click the [WRITE] button. When the writing
is executed correctly\, the [OK] will be displayed on the window. If it failed, the [NG] and a error message window will ap-
pear. Check the communication port and connection of serial cable and then take steps 3 and 4 again.
5. After setting, confirm that the correct model name is displayed on the on-screen menu.
3. 6. Model no. setting
1. Required equipment
1. PC : Use for model no. setting
2. Communication cable : D-sub 9pin (male/female RS-232C straight)
2. Communication cable : D-sub 9pin (male/female RS-232C straight)
3. Software : ModelNameWritingTool.exe
(Download from the projector service home page.)
2. Preparation
1. Move the folder "ModelNameWritingTool" to your favorite directory on your Computer. There are files in the folder as shown
below .
- ModelNameWritingTool.exe
Model no. setting software
- ModelNameWritingTool.ini
Setting file
2. Connect the serial terminal of projector and PC with an
RS-232C cable.
[Note] Setup the projector not to enter the standby mode
or shutdown mode during the working.
Communication cable (straight)
D-Sub 9p (Male)
D-Sub 9p (Female)
Projector Connection terminals
Computer
3. Setting up procedure
1. Connect the AC cord and turn the projector on or set the projec-
tor into the normal standby mode.
2. Double click the icon of software [ModelNameWritingTool.exe]
in the folder of "ModelNameWritingTool ".
3. Select the [Setting] sub menu from [Option[] menu, and setup
the serial communication port.
Port: Select an available port from COM1 to COM6.
Baud Rate: Select 19200bps.
Click on the first or last page to see other PT-TW350 / PT-TX410 / PT-TX320 (serv.man3) service manuals if exist.