PT-RZ575 (serv.man2) - Panasonic Projector Service Manual (repair manual). Page 7

7

  The specifications of the projector are as follows.

100 V - 240 V ~ (100 V - 240 V alternating current), 50 Hz/60 Hz

110 V ~ (110 V alternating current), 60 Hz

500 W (5.9 A - 2.3 A)

500 W (5.2 A)

When [STANDBY MODE] is set to [ECO]: approx. 0.5 W
When [STANDBY MODE] is set to [NORMAL]: approx. 10 W
When [IN STANDBY MODE] in [AUDIO SETTING] is set to [ON], and the [QUICK STARTUP] function is 

disabled: approx. 22 W
When the [QUICK STARTUP] function is enabled: approx. 50 W

17 mm (0.67") (aspect ratio 16:10)

DLP chip x 1, DLP projection system

Number of pixels 2 304 000 pixels (1 920 x 1 200 dots)

Fixed: 0.8:1
Electric focus: F = 1.75, f = 11.9 mm

Laser

5 000 lm

*1

, 5 200 lm (center)

*2

(Both values are measured when [OPERATING MODE] is set to [NORMAL].)

20 000:1 (when [DYNAMIC CONTRAST] is set to [ON])

7 standards (NTSC/NTSC4.43/PAL/PAL-N/PAL-M/SECAM/PAL60)

1.02 m (40") to 7.62 m (300")

16:10

[FRONT/REAR]/[FLOOR/CEILING]

3.0 m (118-1/8")

Molded plastic

498 mm (19-5/8")

168 mm (6-5/8") (with the feet at shortest position)

481 mm (18-15/16") (including lens)

Approx. 16.6 k] (36.5 lbs.)

*3

33 dB

0 °C (32 °F) to 45 °C (113 °F)

*4

10 % to 80 % (no condensation)

DC 3 V (AAA/R03/LR03 battery x 2)

Operating range Within approx. 30 m (98'5") (when operated directly in front of signal receiver)
Weight

102 ] (3.6 ozs.) (including batteries)

Width: 48 mm (1-29/32"), Height: 145 mm (5-23/32"), Depth: 27 mm (1-1/16")

*1  Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2012 international standards.

*2  The value of the light output at the center region of the projected image is extracted based on the light output measurement method defined by the

ISO/IEC 21118:2012 international standards.

*3  Average value. Weight varies for each product.

*4  The operating environment temperature should be between 0 °C (32 °F) and 40 °C (104 °F) if the projector is used at an altitude between 1 400 m

(4 593') and 4 200 m (13 780') above sea level. When the [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE] is set 

to [ECO], [SILENT], [LONG LIFE1], [LONG LIFE2], or [LONG LIFE3], the projector cannot be used at an altitude of 2 700 m (8 858') or higher above 

sea level.

When using the projector at an altitude lower than 2 700 m (8 858') above sea level, and the operating environment temperature becomes 35 °C 

(95 °F) or higher, the light output may be reduced to protect the projector. When using the projector at an altitude between 2 700 m (8 858') and 

4 200 m (13 780'), and the operating environment temperature becomes 25 °C (77 °F) or higher, the light output may be reduced to protect the 

projector.

 

f

The model numbers of accessories and optional accessories are subject to change without prior notice.