Read Panasonic PT-RZ575 (serv.man2) Service Manual online
INF-11
SECTION 1 SERVICE INFORMATION
< RZ575 >
(15) --- LD check (Number of the active laser elements in each LD unit.)
(16) --- Fans control check (1: normal / 0: abnormal)
(17) --- Luminance sensor check (Detected value:Red/Green/Blue/Yellow)
(18) --- Atmospheric pressure sensor check (hpa/Celsius)
(19) --- Angle sensor check (Horizontal angle/Vertical angle)
• Set as follows before checking.
DYNAMIC CONTRAST
OFF
OPERATING MODE
NORMAL
BRIGHTNESS CTRL GAIN
100%
LD2 LD3 LD
4
LD1
E
X
H
AU
S
T1
E
X
H
AU
S
T2
C
E
N
TER
H
E
AT
PI
P
E1
H
E
AT
PI
P
E
2
D
M
D
C
IR
C
U
I I
N
3. AUTO INDEX CALIBRATION
• When replaced the phosphor wheel or color wheel, perform automatic adjustment of each wheel rotational phase.
* Please refer to SECTION 3 (Adjustments) for the procedure.
4. PW INDEX
• Make the rotation phase adjustment of the wheels individually. (Do not change the setting, usually.)
5. CW INDEX
6. POWER OFF MESSAGE
• Operation setting of shutter at standby operation.
- SHUTTER KEEP: When pushing the standby key while the shutter mode is on, the projector keeps the shutter mode
on and sets into standby mode.
- SHUTTER OPEN: When pushing the standby key while the shutter mode is on, the projector opens the shutter and
displays the "Power OFF confirmation message". (Default setting)
7. ERROR OSD
• Enables to display the error information of the LIGHT indicators on the screen.
(It is useful when using the projector with rear projection mode)
- ON : "LD1\LD2 ERROR" is displayed on the screen if the lighting error occurs.
(It will disappear when any of the control buttons is pressed.)
- OFF : No message is displayed on the screen if the lighting error occurs. (Default setting)
8. MODEL
• This setting is necessary when the A-P.C. Board is replaced with new one.
* If you can copy EEPROM data from old A-P.C. Board, this setting is unnecessary.
* This model setting is effective after power restart.
9. LIGHT SELECT
• Select the LD to turn on. Press the [ENTER] key to switch.
- ALL : Both of LD1/LD2 turn on (Default)
- BANK1/2 : LD1 and LD2 turns on
- BANK3/4 : LD3 and LD4 turns on
• The selection will be reset to "ALL" after turning off the projector.
10. UNIFORMITY GRID MODE
• Set up the grid resolution for UniformityTool.
- 1 : Grid resolution 8 x 8
- 2 : Grid resolution 32 x 20 (Default)
11. LENS SHIFT OVER SCAN
• Set up for widen the adjustment range of the lens shift(optical axis shift).
- OFF : The adjustment range no change.
- ON : The adjustment range is widened. (Default)
* Part of the peripheral image may not be visible when the lens position is shifted to the end of adjustment range.
* If changed the settings, lens calibration necessary.
Click on the first or last page to see other PT-RZ575 (serv.man2) service manuals if exist.