Read Panasonic PT-RCQ10 / PT-RCQ80 (serv.man3) Service Manual online
ADJ-9
SECTION 3 ADJUSTMENTS
< RCQ10 / RCQ80 >
1. 5. 4. Restore the backup EEPROM data (after PCB replaced)
1. Start up service software [LogTool.exe] with a computer according to steps 1 - 4 of "1. 5. 3. Backup the EEPROM data
(before PCB exchange)" and connect it to the projector.
2. Restore the EEPROM data by the following procedure.
① Select the projector name to send the EEPROM data.
② Select a [Service] tab.
③ Check-mark [Replace A-Pwb] in "Data Restore".
④ Click [Send] button in "Data Restore".
3. Select the saved file and click [OPEN(O)] button.
4. Once the progress bar reaches the right side end and when the "Complete" dialog window appears, it is complete the writ-
ing.
5. Click [OK] button to close the window and quit the software.
Turn off the main switch and on again, and then check the projector operates normally.
③
④
①
②
Click on the first or last page to see other PT-RCQ10 / PT-RCQ80 (serv.man3) service manuals if exist.