PT-MZ16K, PT-MZ13K, PT-MZ10K (serv.man2) - Panasonic Projector Service Manual (repair manual). Page 4

Read Panasonic PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) Service Manual online

4
PREFACE
<MZ16K/MZ13K/MZ10K>
 
r
Projection in all 360° direction is possible.
360°
360°
360°
360° vertically
360° horizontally
360° tilted
(Combination of vertical and horizontal)
 
r
Cautions when setting up the projector
 
f
Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other purposes 
may damage the projector.
 
f
Do not stack projectors on top of each other.
 
f
Do not use the projector supporting it by the top.
 
f
Do not block the ventilation ports (intake and exhaust) of the projector.
 
f
Prevent hot and cool air from the air conditioning system to blow directly to the ventilation ports (intake and exhaust) of the 
projector.
 
r
The projector may not work properly due to strong radio wave from the broadcast station or the radio.
 
f
If there is any facility or equipment which outputs strong radio waves near the installation location, install the projector at a 
location sufficiently far from the source of the radio waves. Or, wrap the LAN cable connected to the <DIGITAL LINK/LAN> 
terminal using a piece of metal foil or a metal pipe which is grounded at both ends.
 
r
Focus adjustment
 
f
The high clarity projection lens is thermally affected by the light from the light source, making the focus unstable in the pe-
riod just after switching on the power. When the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] 
is set to [OFF], it is recommended to perform the focus adjustment after 30 minutes or more have elapsed with the focus 
test pattern displayed. 
For details of [ACTIVE FOCUS OPTIMIZER], refer to the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OP-
TIMIZER]. 
For details of the test pattern, refer to “[TEST PATTERN] menu”.
 
r
Do not install the projector at an altitude of 2 700 m (8 858') or higher above sea level.
 
r
Do not use the projector in a location that the ambient temperature exceed 45 °C (113 °F).
 
f
Using the projector in a location that the altitude is too high or the ambient temperature is too high may reduce the life of the 
components or result in malfunctions.
Page of 116
Display

Click on the first or last page to see other PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) service manuals if exist.