PT-MZ16K, PT-MZ13K, PT-MZ10K (serv.man2) - Panasonic Projector Service Manual (repair manual). Page 18

INF-8

Chapter 4 Settings — Menu navigation

ENGLISH - 77

4) Press as to select a sub-menu, and press qw or the <ENTER> button to change or adjust settings.

 

f

Some items will switch in order as follows each time you press qw.

A

B

C

 

f

For some items, press qw to display an individual adjustment screen with a bar scale as shown below.

 

f

Pressing the <MENU> button while the menu screen is displayed returns to the previous menu.

 

f

Some items or functions may not be adjusted or used for certain signals to be input to the projector. When the items cannot be adjusted or 

used, the items in the menu screen are shown in black characters, and they cannot be adjusted or set.

If the item in the menu screen is displayed in black characters and the item cannot be adjusted or set, the factor causing it is displayed by 

pressing the <ENTER> button while the corresponding menu is selected.

f

  Some items can be adjusted even if signals are not input.

f

  Individual adjustment screen is cleared automatically if no operation is performed for approximately five seconds.

f

  For menu items, refer to “Main menu” and “Sub-menu” .

f

  The cursor color depends on the setting in the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD DESIGN]. The selected item 

is displayed with the yellow cursor by the factory default.

f

  In the portrait setting, the on-screen menu is displayed sideways.

To display the on-screen menu vertically, change the setting of the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD 

ROTATION].

If the <DEFAULT> button on the remote control is pressed, the values adjusted in the menu items are restored to 

the factory default settings.

 

f

You cannot reset all the settings to the factory default at a time.

 

f

To reset all the settings adjusted in the sub-menu items to the factory default at a time, execute the [PROJECTOR SETUP] menu → 

[INITIALIZE].

 

f

Some items cannot be reset to the factory default settings even when the <DEFAULT> button on the remote control is pressed. Adjust those 

items individually.

 

f

The triangular mark under the bar scale in the individual adjustment screen indicates the factory default setting. The position of the triangular 

mark varies according to the selected input signals.

Current adjustment value

Factory default setting

The following items are in the main menu.
When a main menu item is selected, the screen changes to a sub-menu selection screen.
The menu item with l in the [SIMPLE] mode column indicates that this is displayed in the menu screen (OSD) 

when the [DISPLAY OPTION] menu → [MENU MODE] is set to [SIMPLE].

[PICTURE]

l

[POSITION]

l

[ADVANCED MENU]

―