Read Panasonic PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) Service Manual online
INF-2
SECTION 1 SERVICE INFORMATION
<MZ16K/MZ13K/MZ10K>
1. The name of each part
1.1. Remote controls
Chapter 1 Preparation — About your projector
ENGLISH - 27
About your projector
Remote control
1
3
2
4
5
5
7
6
8
9
10
15
12
11
13
14
16
17
Front
Top
Bottom
1 Power standby <v> button
Sets the projector to the state where the projector is turned
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
2 Power on <b> button
Sets the projector to projection mode when the <MAIN
POWER> switch on the projector is set to <ON> and the power
is turned off (standby mode).
3 Remote control indicator
Blinks if any button in the remote control is pressed.
4 Lens buttons (<FOCUS>, <ZOOM>, <SHIFT>)
Adjusts the focus, zoom, and lens shift.
5 <MENU> button/<ENTER> button/asqw buttons
5 <MENU> button/<ENTER> button/asqw buttons
Used to navigate through the menu screen.
asqw
asqw
buttons are also used to enter the password in
[SECURITY] or enter characters.
6 <ON SCREEN> button
Switches the on-screen display function on (display) or
off (hide).
7 Input selection buttons (<RGB1/2>, <DIGITAL LINK>,
<DVI-D>, <SDI>, <HDMI>)
Switches the input signal to project.
The <VIDEO> button is not used with this projector.
8 <FUNCTION> button
Assigns a frequently used operation as a shortcut button.
When the <FUNCTION> button is held down, the
[FUNCTION
BUTTON] screen is displayed.
9 Number (<0> - <9>) buttons
Used for entering an ID number or a password in a multiple
projector environment.
10 <AUTO SETUP> button
Automatically adjusts the image display position and signal level
while projecting the image.
[PROGRESS] is displayed while in automatic adjustment.
11 <SHUTTER> button
Used to temporarily turn off the image.
12 <TEST PATTERN> button
12 <TEST PATTERN> button
Displays the test pattern.
13 <STATUS> button
Displays the projector information.
14 <DEFAULT> button
Resets the setting of the displayed sub-menu to the
factory default.
15 <ID SET> button
Sets the ID number of the remote control in a multiple
projector environment.
16 Remote control signal transmitter
17 Remote control wired terminal
17 Remote control wired terminal
This is a terminal used to connect to the projector via a
cable when the remote control is used as a wired remote
control.
Attention
f
Do not drop the remote control.
f
Avoid contact with liquids or moisture.
f
Do not attempt to modify or disassemble the remote control.
f
Observe the following instructions that are indicated on the caution label at the back of the remote control:
g
Do not use old battery with new one.
g
Do not use batteries other than the type specified.
Click on the first or last page to see other PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) service manuals if exist.