Read Panasonic PT-F100NTU / PT-F100NTE / PT-F100NTEA / PT-F100U / PT-F100E / PT-F100EA Service Manual online
shifted by your fingers.
Note:
·
The panel adjustment fittings set (panel attachment,
panel adjuster and base plate) is an option for
service.
panel adjuster and base plate) is an option for
service.
6. Reassemble
the
projector
in
the
reverse
order
of
disassembling, but leave the upper case and the screws
fixing the A-P.C.Board block as they are removed.
fixing the A-P.C.Board block as they are removed.
7. Adjust the convergence according to the section 8.4.
"Convergence Adjustment".
8. After the adjustment, while paying attention not to vary the
adjusting result, tighten the 2 screws fixing the panel
attachment with a hexagon head wrench.
attachment with a hexagon head wrench.
Notes:
·
Prepare a hexagon head wrench processed short.
9. Reassemble the projector as it was.
7.20. LCD Panel Discrimination
ID-tag seal color
LCD panel
Red
LCD panel (R)
Blue
LCD panel (B)
(No seal)
LCD panel (G)
·
Since the ID-tag seal is pasted to the FPC of LCD Panel,
(R), (G) or (B) can be easily identified by the color of the
seal.
(R), (G) or (B) can be easily identified by the color of the
seal.
·
Finally, identify the panel color by the part number printed
on the FPC.
on the FPC.
7.21. LCD Panel Combination
·
Part number is printed on the FPC of LCD Panel.
·
When replacing LCD Panel, use a component which has
the same part number as the original.
the same part number as the original.
LCD
panel
Combination1
Combination2
R
L5BDAYY00068
(L3P07X-65G01)
L5BDAYY00071
(L3P07X-66G01)
G
L5BDAYY00072
(L3P07X-66G01)
L5BDAYY00069
(L3P07X-65G01)
B
L5BDAYY00070
(L3P07X-65G01)
L5BDAYY00073
(L3P07X-66G01)
7.22. Replacement of Incidence
Polarizer (G)
1. Remove the A-P.C.Board block according to the steps 1
through 4 in the section 7.3. "Removal of A-P.C.Board".
2. Mark positions of the incidence polarizer (G).
Note:
·
Mark accurately as possible because the marks will
be
be
used
for
resetting
the
incidence
polarizer
position.
3. Unscrew the 1 screw and remove the incidence polarizer
(G).
4. Attach a new incidence polarizer (G) and align it with the
mark.
5. Tighten the 1 screw with care not to move the incidence
polarizer position.
19
PT-F100NTU / PT-F100NTE / PT-F100NTEA / PT-F100U / PT-F100E / PT-F100EA
Click on the first or last page to see other PT-F100NTU / PT-F100NTE / PT-F100NTEA / PT-F100U / PT-F100E / PT-F100EA service manuals if exist.