Read Panasonic PT-DZ780 / PT-DW750 / PT-DX820 / PT-DZ780BE / PT-DZ780LBE / PT-DZ780LWE / PT-DZ780WE / PT-DW750BE / PT-DX820BE / PT-DX820LBE (serv.man2) Service Manual online
SECTION 1 SERVICE INFORMATION
< DZ780/DW750/DX820 >
(15) Model setting state
- YES : Set to the Asia model
- NO : Set to the non Asia model
- NO : Set to the non Asia model
(16) Communication status of the WL-Module
- YES : Communication good
- NO : Communication error (faulty or disconnected)
- NO : Communication error (faulty or disconnected)
(17) Firmware version of IC on the WL-Module
(18) Usage environmental information
(18) Usage environmental information
・
Applicable country Information / Non applicable country Information
(19) Functional restriction setting
- YES : Function restriction has been canceled
- NO : Function restriction has been enabled
- NO : Function restriction has been enabled
(20) Function restriction countdown
・
Counter at the time of communication error / Counter at the time of environmental error
・
Count is decreased when an error is detected.
AND become restricted with counter " 0 ". (Maximum 30)
AND become restricted with counter " 0 ". (Maximum 30)
4. CW INDEX
f
When replaced the color wheel, perform adjustment of color wheel rotational phase.
* Refer to [SECTION 3 Adjustments] for the procedure.
5. POWER OFF MESSAGE
f
Operation setting of shutter at standby operation.
- SHUTTER KEEP: When pushing the standby key while the shutter mode is on, the projector keeps the shutter
mode on and sets into standby mode.
- SHUTTER OPEN: When pushing the standby key while the shutter mode is on, the projector opens the shutter
and displays the "Power OFF confirmation message". (Default setting)
6. ERROR OSD
f
The screen display setting of the LAMP errors. (for projection from rear)
- ON: If the lamp error occurrence, a message will appear on the screen.
- OFF: Lamp error message does not appear on the screen. (Default setting)
- OFF: Lamp error message does not appear on the screen. (Default setting)
7. MODEL
f
This setting is necessary when the A-P.C.Board is replaced.
* If you can copy EEPROM data from the old A-P.C.Board, this setting is unnecessary.
* This model setting is effective after power restart.
* This model setting is effective after power restart.
8. CLOG SENSOR CALIBRATION
f
This is to calibrate the clog sensor circuit.
This calibration is necessary when the A-P.C.Board, EEPROM (IC3518) or M2-P.C.Board is replaced.
This calibration is necessary when the A-P.C.Board, EEPROM (IC3518) or M2-P.C.Board is replaced.
* Refer to [SECTION 3 Adjustments] for the procedure.
3. 3. 2. Additional function of each menu
1. [PICTURE] menu
f
Will be added the following items by pressing the ENTER button at "PICTURE MODE".
1) [Ye MODULATE]
- ON : Enable the yellow color correction function.
- OFF : Disable the yellow color correction function. (default)
- OFF : Disable the yellow color correction function. (default)
2) [DYNAMIC RGB BOOSTER]
- Adjust the image adaptive lamp modulation system effect manually.
[OFF, 1-7 step]
INF - 11
Click on the first or last page to see other PT-DZ780 / PT-DW750 / PT-DX820 / PT-DZ780BE / PT-DZ780LBE / PT-DZ780LWE / PT-DZ780WE / PT-DW750BE / PT-DX820BE / PT-DX820LBE (serv.man2) service manuals if exist.