Read Panasonic PT-DZ16KU / PT-DZ16KE / PT-DS16KD (serv.man16) Service Manual online
ET-LAD510F (4 pcs)
Lamp replacement cycle
Optional upgrade kit
Use lead free solder in servicing from the standpoint of antipollution for the global environment.
It dose not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service
or repair the product or products dealt with in this service information by anyone else could result in serious injury or death.
(Refer to “PROJECTOR SETUP menu” in Operating Instructions.)
Failure to observe this may cause malfunctions. Never use this projector at an altitude of 2,700m or higher.
Using this projector at high altitude, consult your dealer or Authorized Service Center about preparations.
Replace only with the same of equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
・ Be precautious about lead free solder. Sn-Ag-Cu (tin, silver and copper) will tend to splash when heated too high (approx. 600°C or higher).
・ Use lead free solder for the P.C.Board (specified on it as “PbF”) which uses lead free solder. (When you unavoidably use lead solder, use lead
・ solder after removing lead free solder. Or be sure to heat the lead free solder until it melts completely, before applying lead solder.)
・ After soldering to double layered P.C.Boards, check the component side for excess solder which may flow onto the opposite side.
For the P.C.Board which applies lead free solder, the symbol as shown in the figure below is printed or stamped on the surface
or the back of P.C.Board.
diagram. It is essential that these critical parts should be replaced with manufacturer’s specified parts to prevent shock, fire, or other
hazards. Do not modify the original design without permission of Panasonic System Communications Company of North America.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
or other equipment, or the air from the air conditioner does not blow toward the front of the projector.
The operating environment temperature of the projector should be between 0 °C (32 °F) and 45 °C (113 °F) when
using it at elevations lower than 1 400 m (4 593') above sea level, and between 0 °C (32 °F) and 40 °C (104 °F) when
using it at high altitudes (between 1 400 m (4 593') and 2 700 m (8 858') above sea level).
If you use the Smoke cut filter, the operating environment temperature should be between 0 °C (32 °F) and
35 °C (95 °F). However, it cannot be used at high altitudes.
Do not install the projector at elevations of 2 700 m (8 858') or higher above sea level.
2. OSD Menu Navigation
3. Service Mode
4. External Controls
5. Notification for service operation
2. Disassembly Instructions
2. Software update procedure
2. Interconnection Block Diagram
3. Schematic Diagram
4. Circuit Boards Diagram
2. Replacement Parts List