KX-CL400 - Panasonic Copying Equipment Service Manual (repair manual). Page 113

Read Panasonic KX-CL400 Service Manual online

7.3.7. Fusing
After toner image has been applied to the paper, it passes through the fuser. When the BK motor starts to rotate, the IH coil is
turned on, heating the heat roller. As a result, the fuser belt, contacted with the heat roller surface, is heated by the heat roller. A
heated fuser belt melts the toner and pressure drives it into the paper. The melted toner bonds to the paper. After fusing, the paper
advances to the output tray. When the printer is idle, the IH coil is turned off and the fuser belt is not heated. At the 600 dpi printing
mode, the fuser belt is set to approximately 175°C. This fuser belt temperature varies depending on 1200 dpi printing mode, thick
paper printing mode, transparency printing mode, etc. The fuser unit has the paper ejection sensor, which detects the sheet of
paper as it leaves the fuser.
113
KX-CL400
Page of 127
Display

Click on the first or last page to see other KX-CL400 service manuals if exist.