Read Panasonic FA-S680 Service Manual online
6-4
A
B
A
B
60mm
+/– 1 mm
+/– 1 mm
Install the paper guide to the copier.
(2 screws, M4 x 12)
3
Shipping material/Procedure
Check
Location
SU010
SU010
4
Install the floor plate to the system console.
(2 screws, M4 x 14)
Note: Press down the floor plate before
tightening the screws.
5
Height adjustment
This adjustment is only required under following
conditions:
a) The height between the copier top cover (left)
This adjustment is only required under following
conditions:
a) The height between the copier top cover (left)
and the sorter top cover is not 60 mm +/– 1 mm.
b) The gap between the copier and sorter is not
equal ("A" and "B").
Right side (front/rear)
1
Loosen the nuts on the casters.
2
Turn the caster nut clockwise or
counterclockwise so the height between the
copier top cover (left) and sorter top cover is
within 60 mm +/– 1 mm.
counterclockwise so the height between the
copier top cover (left) and sorter top cover is
within 60 mm +/– 1 mm.
(use a wrench)
3
Retighten both nuts (front/rear) after this
adjustment is done while holding the caster.
adjustment is done while holding the caster.
(tighten the caster nuts by wrench "B")
Left side (front/ rear)
Left side (front/ rear)
1
Remove the caps. (2 caps)
2
Loosen the nuts on the casters.
3
Turn the caster clockwise or
counterclockwise so the gap "A" and "B" are
equal. (use a (–) screwdriver)
counterclockwise so the gap "A" and "B" are
equal. (use a (–) screwdriver)
4
Retighten both nuts (front/rear) after this
adjustment is done while holding the caster.
adjustment is done while holding the caster.
(tighten the caster nuts by wrench "B")
Size of wrench: Wrench "A":19 mm (for nuts)
Size of wrench: Wrench "A":19 mm (for nuts)
Wrench "B": 21 mm (for caster nuts)
SU005
SU030
1
1
Click on the first or last page to see other FA-S680 service manuals if exist.