DP-8020E, DP-8020P, DP-8016P (serv.man2) - Panasonic Copying Equipment Service Manual (repair manual)

Order Number: MGCS060806C0

H21

This service information is designed for experienced repair technicians only and is not intended for use by the general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service 
or repair the product or products dealt within this service information by anyone else could result in serious injury or death.

2

3

9. 

    This product is fully compliant with the national laws transposed from the EU Directive 

    on the restriction of the use of certain hazardous substances (RoHS) in electrical and 

    electronic equipment, effective 1st July 2006 in the EU countries.

    In order for the product to comply with the RoHS Directive, the six particular substances 

    (lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyls, and 

    polybrominated diphenyl ethers) have been either totally eliminated or limited to the 

    concentration level below maximum allowed.  Consequently spare parts have been 

    changed to RoHS-compliant parts where applicable.

   To ensure compliance with the spare parts application of the RoHS legislation, please 

    make sure to follow the details provided in this manual when ordering spare parts and

    carrying out repairs.

The contents of this Service Manual, and the Specifications are subject to change 
without notice. Panasonic Communications Co., Ltd. reserves the right to make 
improvements in the product design without reservation and without notice.
Published in Japan.

4

Please read these Instructions completely BEFORE installing any optional 
accessories. Installing the additional board, or connector with the power ON 
(only the power switch OFF) could damage the SPC, and/or SC board.

If the Hard Disk Drive Unit is installed, to prevent a Disk Scan Function from 
being performed (similar to when the power is abruptly interrupted to the PC), 
it is important to follow the step sequence below when turning OFF the Power 
Switch on the machine.

1. If the machine is in the "ENERGY SAVER 
    (Shutdown Mode)", you may turn the 
    Power Switch on the machine to the 
    OFF position. If it is not in the "ENERGY 
    SAVER (Shutdown Mode)", continue to 
    step 2 below.
2. Press "FUNCTION" and "ENERGY SAVER" 
    keys simultaneously first.
3. Wait approximately 10 seconds while 
    the machine writes the closing status onto 
    the Hard Disk Drive Unit, and advances into 
    "ENERGY SAVER MODE".
4. Turn the Power Switch on the machine to the OFF position.
5. Disconnect the Telephone Line Cable, if the Fax Option 
    is installed.
6. 

Unplug the AC Power Cord.

   

  

(When the Fax option is installed, there is a remote possibility of electrocution when 

      servicing the unit during a Lightning Storm. As a precaution, disconnect the Telephone 
      Line Cable first, before unplugging the AC Power Cord.

This service information is designed for experienced repair technicians only and is not intended for use 
by the general public. It does not contain warnings or cautions to advise non-technical individuals of 
potential dangers in attempting to service a product. Products powered by electricity should be serviced 
or repaired only by experienced professional technicians. Any attempt to service or repair the product or 
products dealt within this service information by anyone else could result in serious injury or death.

* The specifications are subject to change without notice. Panasonic Communications Co., Ltd. reserves 
  the right to make improvements in the product design without reservation, and without notice.