TX-P50ST60B, TX-P50ST60Y, TX-PR50ST60 (serv.man2) - Panasonic Plasma Service Manual (repair manual). Page 30

30

Name of measuring instrument

Remarks

Color analyzer 

(Minolta CS-2000 or equivalent)

Procedure

Remarks

1. Enter the Service mode.
2. Receive the Analog-RF (except for no signal) or set CVBS/YUV/HDMI (no signal is 

available).

3. Select [WB-ADJ] by using [1] and [2] key in the remote controller.
4. Check that the colour balance and the viewing mode is the values written in table1 and 2.
5. [INNER PATTERN] is displayed by using [5] key by using [5] key in the remote controller.
6. Select [G-CUTOFF] by using the [3] and [4] key in the remote controller, and set the value 

to [80] by using the volume [+] and [-] key.
Also, [B-CUTOFF] and [R-CUTOFF] set to [80]

7. Set [G-DRIVE] value to the initial data (ex. D0).
8. Set the color analyzer and adjust color point to the values written in table1 by using [B-

DRIVE] and [R-DRIVE]

9. Increase RGB-DRIVE value so that the maximum drive value of one of R-DRIVE or G-

DRIVE or B-DRIVE should become [FF]
([ALL-DRIVE] set to [FF].)