KX-NCP1180X - Panasonic PBX Service Manual (repair manual). Page 11

Read Panasonic KX-NCP1180X Service Manual online

11
     KX-NCP1180X
4.2.2.5.
End-Call Signal Detection
This is detected by the photo coupler (pin 4 of PC4) at part of making DC loop. PC4 4-pin is High level during a call. However, at
end-call, PC4 4-pin converts from High to Low.
It detects an end-call with measuring of the signal width of Low level by CODEC (e.g. pin 35 of IC203, CPCDET).
The available setting values for detection width are none, 0.5msec-8msec(at 2msec intervals) and 16~896msec(at 8msec inter-
vals).
4.2.2.6.
Polarity Reversal Detection
Configured by the photo couplers (PC1, PC2) that enable to detect each current in Tip
→Ring, Ring→Tip direction. (PC2 is used
in common as the bell detection photo coupler). Using Software, it stores the current direction (the detected photo coupler) at
acquiring line and recognizes the action by changing of the current direction (the detected photo coupler changes).
When the current flows in the direction of Ring to Tip, 4-pin of PC1 is Low and 4-pin of PC2 is High.
• Ring
→L1→R2→PC1(1-2)→D3→RL3→Q6(C-E)→D4→D3→RL1→J2→L1→J1→Tip
When the current direction (polarity) is reversed from Tip to Ring, 4-pin of PC1 turns to High and 4-pin of PC2 turns to Low. It
recognizes the action by changing of the current direction (the detected photo coupler changes).
• Tip
→J1→L1→D3→RL3→Q6 (C-E)→D4→D3→PC2 (1-2)→R2→L1→Ring
Page of 50
Display

Click on the first or last page to see other KX-NCP1180X service manuals if exist.