Read Panasonic UB-8325 Service Manual online
18
UB-8325
Step
Points to Check
Symptom
Solutions
1
Turn on the power switch.
(If not)
2
Open the printer door and attach the
accessory thermal transfer film, then
close the printer door.
• Installing Thermal Transfer Film
accessory thermal transfer film, then
close the printer door.
• Installing Thermal Transfer Film
procedure
“ ” flashes.
(If not)
Check power cord.
(Normal operation)
(Normal operation)
(Normal operation)
Check thermal transfer film.
(refer to the Operating Instructions)
3.3.3 Electronic Board Operations Check
After assembling the electronic board, perform the procedures presented in the following table to make sure it
functions properly.
functions properly.
4. Connect the power cord.
1) Securely fit the supplied power cord into the
AC inlet on the printer unit.
6. Check operations.
Refer to the following section, and perform the
“Electronic Board Operations Check”.
“Electronic Board Operations Check”.
5. Wipe the screen film surface.
Soak a soft cloth with water, wring well, and
wipe the screen film surface.
wipe the screen film surface.
•
•
Caution
Do not wipe the screen film surface with paint thinner,
benzene, or cleaners that contain abrasives.
Doing so may cause discoloration.
benzene, or cleaners that contain abrasives.
Doing so may cause discoloration.
Do not wipe the screen film surface with a dry cloth.
Doing so may create static electricity.
Doing so may create static electricity.
“ ” flashes after “ ” lights up.
2) Fasten the power cord through the center
cable holder, as well as the left or right cable
holder depending on the location of the AC
outlet (see below).
holder depending on the location of the AC
outlet (see below).
• Left Location
When fastening through the left cable holder,
fasten the power cord through the cable
holders as shown below:
fasten the power cord through the cable
holders as shown below:
• Right Location
When fastening through the right cable holder,
fasten the power cord through the cable
holders as shown below:
fasten the power cord through the cable
holders as shown below:
Click on the first or last page to see other UB-8325 service manuals if exist.