Read Panasonic KV-S5055C (serv.man4) Service Manual Supplement online
6
3 "SECTION 3 COMPONENT IDENTIFICATION"
3.1.
“Section 3.2 Control Panel”
Fig.3.2.1 Function of Control Panel keys and indications
Fig.3.2.2 Scanner status
Note:*
*1: Interval of blinking: ON for 1 second and OFF for 1 second
*2: Interval of blinking: ON for 1 second and OFF for 3 seconds
*3: Interval of blinking: ON for 0.25 seconds and OFF for 0.25 seconds
*4: To determine the specific condition, execute "Service Utility", and then check the status message.
*5: The scanner will enter Standby mode when no operation is performed for 30 minutes, to save power.
Push any one of the keys on the Control Panel for more than 1 second to restart the scanner.
Waiting time before the scanner enters Standby mode can be set by using Service Utility.
(The default setting value depends on the country/area.)
*2: Interval of blinking: ON for 1 second and OFF for 3 seconds
*3: Interval of blinking: ON for 0.25 seconds and OFF for 0.25 seconds
*4: To determine the specific condition, execute "Service Utility", and then check the status message.
*5: The scanner will enter Standby mode when no operation is performed for 30 minutes, to save power.
Push any one of the keys on the Control Panel for more than 1 second to restart the scanner.
Waiting time before the scanner enters Standby mode can be set by using Service Utility.
(The default setting value depends on the country/area.)
Name
Operation
Remarks
1
DFS (Double-
feed Skip) key
feed Skip) key
When a double-feed occurs, push this key to continue scanning the double-feed detected
sheet and the following sheet on the Hopper.
sheet and the following sheet on the Hopper.
2
Start/Stop key
(1) Push this key to start scanning if you set [Wait Key] to "Manual Feed Mode" in your
application software.
(2) During scanning, push this key to stop scanning.
(3) If you push this key when a double feed occurs, the sheet that was detected as a double
feed will be ejected from the scanner without being scanned. Scanning will stop.
application software.
(2) During scanning, push this key to stop scanning.
(3) If you push this key when a double feed occurs, the sheet that was detected as a double
feed will be ejected from the scanner without being scanned. Scanning will stop.
3
Ready Indicator This indicator shows the scanner status.
4
Error Indicator
This indicator lights when an error occurs.
Ready Indicator
Error Indicator
Status
(Green)
(Red)
ON
OFF
Ready
ON
Blinking (Slow, Long ON)
*1
Caution
*4
OFF
ON
Error
*4
Blinking (Slow, Long ON)
*1
OFF
Sleep
Blinking (Slow, Long ON)
*1
Blinking (Slow, Long ON)
*1
Caution
*4
/ Sleep
Blinking (Slow, Short ON)
*2
OFF
Standby
*5
Blinking (Slow, Short ON)
*2
Blinking (Slow, Long ON)
*1
Caution
*4
/ Standby
*5
Blinking (Fast)
*3
OFF
Warming up
Blinking (2 times consecutively)
OFF
Double Feed Skip mode
Click on the first or last page to see other KV-S5055C (serv.man4) service manuals if exist.