Read Panasonic NN-S453WF / NN-S553WF / NN-K593MF / NN-K573MF / NN-K573WF / NN-K543WF Service Manual online
5.6. Turntable motor
1. Remove the motor cover by cutting at the locations
indicated by the arrows with a cutter.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the inside
so that no sharp edges will be exposed to outside.
portions are properly trimmed or bent to the inside
so that no sharp edges will be exposed to outside.
2. Disconnect 2 lead wires connected to the turntable motor.
3. Remove the turntable motor by removing screw.
NOTE:
After
replacing
the
new
turntable
motor
and
reconnecting the two lead wires, reinstall the motor
cover by rotating it 180°, tucking the tabs into the
base in the 2 provided slots, then screw the single
tab to the base using a 4mm X 6mm screw (not
provided).
cover by rotating it 180°, tucking the tabs into the
base in the 2 provided slots, then screw the single
tab to the base using a 4mm X 6mm screw (not
provided).
5.7. Steam sensor
1. Disconnect connector CN2 from digital programmer circuit
board.
2. Disengage catch hooks on sensor cover c from orifice.
3. Remove steam sensor from orifice.
NOTE:
When installing the steam sensor, make sure that the
direction of steam sensor is as shown in figure.
direction of steam sensor is as shown in figure.
12
NN-S453WF
Click on the first or last page to see other NN-S453WF / NN-S553WF / NN-K593MF / NN-K573MF / NN-K573WF / NN-K543WF service manuals if exist.