NN-E205WB, NN-E235MB, NN-E205WB, NN-E235MB, NN-E205WB, NN-E235MB - Panasonic Home Appliance Service Manual (repair manual). Page 14

1) Open the door.
2) Remove the choke cover cap very carefully with a

flat-blade screwdriver.

3) Lift up and push the door.

NOTE:
1. After replacing the door, be sure to check that the

primary switch, monitor switch, and secondary
switch operate normally.

2. After replacing the door, check for microwave

energy leakage with a survey meter. Microwave
energy must be below the limit of 5 mW/cm

2

.(with

a 275 ml water load)

3. When mounting the door assembly to the oven

assembly, be sure to adjust the door assembly
parallel to the chassis. Also adjust so the door has
no play between the inner door surface and oven
frame assembly. If the door assembly is not
mounted properly, microwaves may leak from the
clearance between the door and the oven.

1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from magnetron, high voltage

transformer, and capacitor.

3) Remove the screw holding the high voltage

transformer to the baseplate.

1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from fan motor, noise filter

and high voltage capacitor.

3) Remove the two screws holding the the suction guide

ASS’Y to the oven cavity and remove the high
voltage diode earth screw.

4) Remove the screw of the capacitor bracket.
5) Remove the two screws holding the fan motor ASS’Y

to the suction guide ASS’Y.

1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from fan motor, noise filter

and high voltage capacitor.

3) Remove the screw holding the suction guide ASS’Y to

the oven cavity and remove the high voltage diode
earth screw.

4) Remove the screw holding the high voltage capacitor

bracket.

5-4

Remove Door Assembly

Remove Door Assembly

H.V.
Capacitor

Suction
Guide

H.V.
Diode

H.V.

Transformer