NN-CD565BZPE - Panasonic Home Appliance Service Manual (repair manual). Page 12

Read Panasonic NN-CD565BZPE Service Manual online

4.5. Door assembly
 1. Remove door C from door E by carefully pulling outward,
starting from upper right hand corner using a flat blade
screwdriver.
 2. Separate door E from tabs on door A and remove door A
(U).
 3. Open Door E at the opening angle of approximately
10°(Note: The door cannot be removed if the opening
angle is greater than 10°).
 4. Remove the door E from its hinges by pushing the door E
upward and out.
 5. Remove door key and door key spring.
To re-install components:
 1. Place the door’s lower hinge pin into the bottom hinge
hole.
 2. Use your left index finger to support the door’s lower
hinge pin while guiding the door’s upper hinge pin into
the top hinge hole.
 3. Lower your finger to seat the door onto the hinges.
 4. Replace other components.
NOTE:
Adjust so that the upper portion of the door will
touch firmly to the oven cavity front plate, without
pushing the door. If the door assembly is not
mounted properly, microwave power may leak from
the clearance between the door and oven.
NOTE:
Always
perform
the
microwave
leakage
measurement test after installation and adjustment
of door assembly.
4.6. Turntable motor
 1. Remove the motor cover by breaking off at the 8 spots
indicated by arrows with a cutter or the like.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the inside
so that no sharp edges will be exposed to outside.
 2. Disconnect 2 lead wires connected to the turntable motor.
 3. Remove the turntable motor by removing screw.
NOTE:
After reinstalling the new turntable motor and
reconnecting the 2 lead wires, reinstall the motor
cover by rotating it around 180, tucking the 2 tabs
under the base in the 2 provided slots, then screw
the single tab to the base using a 4mm × 6mm
screw.
12
NN-CD565B
Page of 34
Display

Click on the first or last page to see other NN-CD565BZPE service manuals if exist.