NA-106VC5WRU - Panasonic Home Appliance Service Manual (repair manual). Page 6

NA-106VC5WRU

6

1. Transportation screws, which are located at the back side

of the machine, must be removed before running the
machine.

2. Loosen the screws by turning them anticlockwise with a

suitable spanner.

3. Pull out the screws and rubber washers.

4. The holes where the transport screws have been

removed should be covered with the plastic transport
caps found in the accessories bag.

5. The transportation screws that have been removed from

the machine must be re-used in any future transporting of
the machine.

1. Do not install  machine on rugs or similar surfaces.
2. For machine to work silently and without any vibration, it

should be installed on a flat, non-slippery firm surface.
Any suspended floor must be suitably strengthened.

3. You can adjust the level of  machine using its feet.
4. First, loosen the plastic adjustment nut away from the

cabinet base.

5. Change the level by adjusting the feet upwards or down-

wards.

6. After level has been reached, tighten the plastic adjust-

ment nut again by rotating it upwards against the base of
the cabinet.

7. Never put cartons, wooden blocks or similar materials

under the machine to balance irregularities of the floor.

1. Washing machine requires a 50Hz supply of 220-

240Volts.

2. A special earthed plug has been attached to the supply

cord of  washing machine. This plug must be fitted to an
earthed socket. The fuse value fitted to this plug should
be 13 amps. If you have any doubts about  electrical sup-
ply, consult a qualified electrician.

1. Washing machine is supplied with a single (cold) water

inlet.

2. To prevent leakage from the connection joints, a rubber

washer is included in the hose packing. Fit this washer at
the end of water inlet hose on the tap side.

3. Connect the hose to the water inlet valve. Tighten the

plastic connector by hand. Please call a qualified plumber
if you are unsure about this.

4. Water pressure of 0,1-1 MPa from  tap will enable

machine to work more efficiently.(0,1 MPa pressure
means water flow of more than 8 litres in 1 minute from a
fully opened tap)

5. After connection is complete, check for leakage by turning

on  tap completely.

6. Make sure that water inlet hoses can not become folded,

damaged, stretched or crushed when the washing
machine is in its final position.

7. Mount the water inlet hose to a 3/4” threaded water tap.

1. Make sure that water inlet hoses are not folded, twisted,

crushed or stretched.

2. The drain hose should be mounted at a minimum height

of 60 cm, and a maximum height of 100 cm from the floor.

3. The end of the drain hose can be connected directly to a

drainage stand-pipe or alternatively to a specific connec-
tion point designed for that purpose on the waste outlet of
a sink unit.  

4. Do not extend the drain hose or  guarantee will be invali-

dated.