Read Panasonic EH2513 / EH2513G865 Service Manual online
Order Number PCD0708E61CE
Pore Cleanser
Model No.
EH2513
EUROPE
TABLE OF CONTENTS
PAGE
PAGE
1 Warning -------------------------------------------------------------- 2
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Wiring Connection Diagram ---------------------------------- 4
5 Schematic Diagram ---------------------------------------------- 4
6 Exploded View and Replacement Parts List ------------ 5
2 Specifications ----------------------------------------------------- 2
3 Troubleshooting Guide ----------------------------------------- 3
4 Wiring Connection Diagram ---------------------------------- 4
5 Schematic Diagram ---------------------------------------------- 4
6 Exploded View and Replacement Parts List ------------ 5
2
1 Warning
Caution:
• Pb free solder has a higher melting point that standard solder; Typicall the melting point is 50 - 70
°F (30 - 40°C) higher. Please
use a soldering iron with temperature control and adjust it to 750 ± 20
°F (400 ± 10°C). In case of using high temperature solder-
ing iron, please be careful not to heat too long.
• Pb free solder will tend to splash when heated too high (about 1100
°F / 600°C).
2 Specifications
3
3 Troubleshooting Guide
• How to clean the filter
- Inlet (Filter)
Turn the Switch off and remove the stains with the attached cleaning brush having a needle.
NOTE: Do not use the Cleaning needle side.
NOTE: Do not use the Cleaning needle side.
- Tank
Turn the Switch off and clean the inside of the Tank with the attached cleaning brush.
- Mist outlet
Turn the Switch off and clean the hole of the Mist outlet with the attached cleaning needle.
• How to drain the water from the Pump
1. Turn the Switch on and shake the Main body approximately ten times to drain the water.
2. Drain the water from the Tank, and dry it by unplugging the tank sealing.
3. Wipe the Main body and the Cup with a tissue or swabs. Especially, wipe the inside the Cup thoroughly.
2. Drain the water from the Tank, and dry it by unplugging the tank sealing.
3. Wipe the Main body and the Cup with a tissue or swabs. Especially, wipe the inside the Cup thoroughly.
4
4 Wiring Connection Diagram
5 Schematic Diagram