Read Panasonic EH-NE50 Service Manual online
6
4.2.
Caution In Assembly
Refer to WIRING DIAGRAM to solder the wires
1. Confirm that the polyester tapes are stuck on the heater
motor block as shown in the following figure.
2. Confirm that there are the aluminum seals (6.0x6.0) on
the both discharge cover, before installing the discharge
electrodes between the ribs.
electrodes between the ribs.
3. Allocate the lead wires between the ribs on the housing B
as shown in the following figure. Then stick the polyester
tape (20.0x70.0) over the lead wires.
tape (20.0x70.0) over the lead wires.
4. Confirm that there is the polyester tape on the igniter until
the back from the capacitor surface.
Click on the first or last page to see other EH-NE50 service manuals if exist.