Read Panasonic EH-NE31 Service Manual online
6
4.2.
Caution In Assembly
Refer to WIRING DIAGRAM to solder the wires
1. Confirm that the polyester tapes are stuck on the heater
motor block as shown in the following figure.
2. Confirm that the aluminum seal is stuck on the discharge
base as shown in the following figure.
3. Attach the heater motor block to housing B by installing
the plates between the ribs.
4. Fix the high voltage lead wire by the polyester tape
(20.0x70.0) on the heater block.
Click on the first or last page to see other EH-NE31 service manuals if exist.