KX-FT57E - Panasonic Fax Service Manual (repair manual). Page 6

|

6

|

This appliance is supplied with a moulded three pin mains plug for your safety and convenience.
A5 amp fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement fuse has rating of
5 amps and that it is approved by ASTA or BSI to BS1362.

Check for the ASTA mark

or the BSI mark

 on the body of the fuse.

If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover
the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local
Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD
BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET.
If a new plug is to be fitted please observe the wiring code as shown below.

 The wires in this mains leads are colored in accordance with the following code:

Green-and-yellow:

Earth

Blue:

Neutral

Brown:

Live

As the colors of the wires in the mains lead of this appliance may not correspond with the colored markings identifying the
terminals in your plug, proceed as follows.
The wire which is colored GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked with the letter
E or by the safety earth symbol

 or colored GREEN or GREEN-AND-YELLOW.

The wire which is colored BLUE must be connected to the terminal in the plug which is marked with the letter N or colored
BLACK. The wire which is colored BROWN must be connected to the terminal in the plug which is marked with the letter L or
colored RED.
How to replace the fuse : Open the-fuse compartment with a screwdriver and replace the fuse and fuse cover.

FUSE

(FOR UNITED KINGDOM)
THE LITHIUM BATTERY IS A CRITICAL COMPONENT
TYPE NUMBER

CR2032

(BATT)

MANUFACTURED BY

MATSUSHITA

CR2032

(BATT)

SONY

IT MUST NEVER BE SUBJECTED TO EXCESSIVE HEAT OR DISCHARGE. IT MUST THEREFORE ONLY BE FITTED
IN EQUIPMENT DESIGNED SPECIFICALLY FOR ITS USE.

REPLACEMENT BATTERIES MUST BE OF AN APPROVED TYPE AND MANUFACTURER AS INDICATED ABOVE.
THEY MUST BE FITTED IN THE SAME MANNER AND LOCATION AS THE ORIGINAL BATTERY, WITH THE CORRECT
POLARITY CONNECTIONS OBSERVED.

DO NOT ATTEMPT TO RE-CHARGE THE OLD BATTERY OR RE-USE IT FOR ANY OTHER PURPOSE. IT SHOULD BE
DISPOSED OF IN WASTE PRODUCTS DESTINED FOR BURIAL RATHER THAN INCINERATION.

WARNING

THE LITHIUM BATTERY IN THIS EQUIPMENT MUST ONLY BE REPLACED BY QUALIFIED PERSONNEL. WHEN
NECESSARY, CONTACT YOUR LOCAL PANASONIC SUPPLIER.