Read Panasonic KX-FLB813RU Service Manual online
118
KX-FLB813RU
12.3.5.2. RECORDING PAPER FEED
No.
Symptom
Cause
Countermeasure
1
MULTIPLE FEED (P.134)
Dirty or failed the pickup roller
Clean or replace the pickup roller
Dirty or failed the pickup rubber
Clean or replace the separation rubber
2
THE RECORDING PAPER
IS WAVED OR WRIN-
KLED (P.135)
IS WAVED OR WRIN-
KLED (P.135)
Dirty the pressure roller or the heat roller
Clean the pressure roller and the heat roller
Failed the spring of pressure roller
Replace the spring of pressure roller
Separator of heat roller a check
Replace separator
Dust on the recording paper path
Clean the recording paper path
Too thin recording paper
Use the recording paper from 16lb to 24lb
3
SKEW (P.136)
Dirty or failed the pickup roller
Clean or replace the pickup roller
Dirty or failed the pickup rubber
Clean or replace the separation rubber
Dirty or failed the paper feed roller
Clean or replace the regist roller
Dust on the recording paper path
Clean the recording paper path
Failed LSU
Replace LSU
Over the max capacity of the recording paper
Set up to MAX 150 sheets
Too thick or too thin recording paper
Use the recording paper from 16lb to 24lb
4
THE RECORDING PAPER
DOES NOT FEED (P.137)
DOES NOT FEED (P.137)
Dirty or failed the pickup roller
Clean or replace the pickup roller
Dirty or failed the pickup rubber
Clean or replace the separation rubber
Failed the gear
Check the gear
Failed the solenoid
Check the solenoid
Failed the engine motor
Go to FB (FlatbedFlatbed) MOTOR (P.172)
Failed the pickup sensor lever
Check the pickup sensor lever
Failed the pickup sensor
Go to SENSOR SECTION (P.168)
5
THE RECORDING PAPER
JAM(P.138)
”PAPER JAMMED” ON
THE LCD
JAM(P.138)
”PAPER JAMMED” ON
THE LCD
Dirty or failed the pressure roller
Clean or replace the pressure roller
Dirty or failed the heat roller
Clean or replace the heat roller
Separator of heat roller a check
Replace separator
Dust on the recording paper path
Clean the recording paper path
Failed the paper feed roller
Replace the registration roller
Failed the pickup sensor lever
Check the pickup sensor lever
Failed the pickup sensor
Go to SENSOR SECTION (P.168)
Failed the resist sensor lever
Check the Registration & Manual paper sensor (paper top sen-
sor) lever
sor) lever
Failed the resist sensor
Go to SENSOR SECTION (P.168)
Failed the exit sensor
Check the Paper Exit sensor lever
Too thick or too thin recording paper
Use the recording paper from 16lb to 24lb
Not set the toner bottle
Set toner bottle
6
BACK SIDE OF THE
RECORDING PAPER IS
DIRTY(P.139)
RECORDING PAPER IS
DIRTY(P.139)
Dirty the recording paper path
Clean the recording paper path
Dirty the pressure roller
Clean the pressure roller
Dirty the regist roller
Clean the registration roller
Failed the high-voltage terminal
Check the high-voltage terminal
Failed the high voltage power supply board
Go to HIGH VOLTAGE SECTION (P.179)
Click on the first or last page to see other KX-FLB813RU service manuals if exist.