SV-AS10EB, SV-AS10EG, SV-AS10GC, SV-AS10GN (serv.man2) - Panasonic Digital Camera Service Manual (repair manual). Page 9

Read Panasonic SV-AS10EB / SV-AS10EG / SV-AS10GC / SV-AS10GN (serv.man2) Service Manual online

When servicing, it is easier if the HOZAN PCB holder (HS-507)
is used.
CSP/0603 Tip
Since the components are mounted with the high-density
component placement (0.2 mm spacing) technology, it is
impossible to use conventional tools.
However, repair becomes possible using the following
recommended tools.
7.1.1. Recommended Tools
Use any one of the following soldering irons.
Unit Part No.: MX-500S-11 or HS-35 with each tip.
Soldering Iron
     ·    High frequency soldering iron
(Be careful of the voltage according to a country)
High frequency soldering iron by METCAL.
Tip is 0603 for rework.
Unit Part No.: MX-500S-11
Tip Part No.: STTC-190 (Tip temperature 370°C)
General Soldering Iron
     ·    MICRO PENSOL by HOZAN.
(Voltage is typed universally)
Unit Part No.: HS-35
Bit Part No.: VFK1882 (Special Bit)
Microscope
     ·    STEREO MICROSCOPE by HOZAN.
(Left and right focuses can be adjusted independently.)
Unit Part No.: L-55
Used for chip parts rework.
Place a PCB on the TABLE.
Lighting System
     ·    LIGHTING SYSTEM by HOZAN.
Unit Part No.: L-65
To be installed to the lens of the above-mentioned
magnifier to illuminate objects.
Vacuum Pic
     ·    VACUUM PIC by HOZAN.
Unit Part No.: P-835
7 CSP REPAIR PROCEDURE
7.1. INTRODUCTION OF THE REPAIR TECHNIQUE FOR CSP/0603
9
SV-AS10EB / SV-AS10EG / SV-AS10GC / SV-AS10GN
Page of 36
Display

Click on the first or last page to see other SV-AS10EB / SV-AS10EG / SV-AS10GC / SV-AS10GN (serv.man2) service manuals if exist.