Read Panasonic DMC-TZ8EB / DMC-TZ8EE / DMC-TZ8EF / DMC-TZ8EG / DMC-TZ8EP / DMC-TZ8GC / DMC-TZ8GN / DMC-ZS5P / DMC-ZS5PC / DMC-ZS5PU / DMC-ZS5GH / DMC-ZS5GK Service Manual online
DMC-TZ8EE
DMC-TZ8EF
DMC-TZ8EG
DMC-TZ8EP
DMC-TZ8GC
DMC-TZ8GN
DMC-ZS5P
DMC-ZS5PC
DMC-ZS5PU
DMC-ZS5GH
DMC-ZS5GK
(S)....................Silver Type (except DMC-TZ8EF)
(K)....................Black Type
1.2. Leakage Current Cold Check ---------------------------3
1.3. Leakage Current Hot Check (See Figure 1)---------3
1.4. How to Discharge the Capacitor on Flash
2.4. How to Replace the Lithium Battery -------------------7
3.2. General Description About Lead Free Solder
5 Location of Controls and Components------------------ 15
6 Service Mode ----------------------------------------------------- 17
6.2. ICS (Indication of additional Camera Settings
7.2. When Replacing the Main P.C.B. -------------------- 23
7.3. Service Position ------------------------------------------ 24
8.2. P.C.B. Location ------------------------------------------- 25
8.3. Disassembly Procedure -------------------------------- 26
8.4. Lens Disassembly Procedure ------------------------- 32
8.5. Assembly Procedure for Lens ------------------------ 35
8.6. Removal of the CCD Unit ------------------------------ 39
8.7. Removal of the Zoom Motor Unit -------------------- 39
8.8. Removal of the Focus Motor Unit -------------------- 40
8.9. The Applyment of Grease Method ------------------- 40
9.2. Before Disassembling the unit ------------------------ 41
9.3. Details of Electrical Adjustment----------------------- 43
9.4. After Adjustment------------------------------------------ 47
which are important for safety. These parts are marked by
tial that these critical parts should be replaced with manu-
facturer’s specified parts to prevent X-RADIATION, shock
fire, or other hazards. Do not modify the original design
without permission of manufacturer.
from the AC power line. Use a transformer of adequate
power rating as this protects the technician from acci-
dents resulting in personal injury from electrical shocks. It
will also protect AC Adaptor from being damaged by acci-
dental shorting that may occur during servicing.
heated or damaged by the short circuit.
properly installed.
shock hazards.
lic cabinet part on the equipment such as screwheads,
connectors, control shafts, etc. When the exposed metal-
lic part has a return path to the chassis, the reading
should be between 1M
(See Figure 1)
and a good earth ground, as shown in Figure 1.
lent) may be used to make the hot checks, leakage cur-
rent must not exceed 1/2 mA. In case a measurement is
outside of the limits specified, there is a possibility of a
shock hazard, and the equipment should be repaired and
rechecked before it is returned to the customer.
2. Be careful of the high voltage circuit on Flash P.C.B. when servicing.
2. Install the insulation tube onto the lead part of Resistor (ERG5SJ102:1k
4. After discharging, confirm that the capacitor voltage is lower than 10V using a voltmeter.