DMC-FT20EE - Panasonic Digital Camera Service Manual (repair manual). Page 6

6

Your attention is drawn to the fact that recording of pre-
recorded tapes or discs or other published or broadcast 
material may infringe copyright laws.

To reduce the risk of fire or shock hazard, do not expose 
this equipment to rain or moisture.

To reduce the risk of fire or shock hazard and annoying 
interference, use the recommended accessories only.

 DO NOT REMOVE THE OUTER COVER
To prevent electric shock, do not remove the cover. No user 
serviceable parts inside. Refer servicing to qualified service 
personnel.

For your safety, please read the following text carefully.

This appliance is supplied with a moulded three-pin mains plug 
for your safety and convenience.
A 5-ampere fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the 
replacement fuse has a rating of 5 amperes and it is approved 
by ASTA or BSI to BS1362
Check for the ASTA mark or the BSI mark on the body of the 
fuse.

If the plug contains a removable fuse cover you must ensure 
that it is refitted when the fuse is replaced.
If you lose the fuse cover, the plug must not be used until a 
replacement cover is obtained.
A replacement fuse cover can be purchased from your local 
Panasonic Dealer.

If the fitted moulded plug is unsuitable for the socket outlet in 
your home then the fuse should be removed and the plug cut 
off and disposed of safety.
There is a danger of severe electrical shock if the cut off plug is 
inserted into any 13-ampere socket.

If a new plug is to be fitted please observe the wiring code as 
shown below.
If in any doubt, please consult a qualified electrician.

The wires in this mains lead are coloured in accordance with 
the following code:

     

As the colours of the wires in the mains lead of this appliance 
may not correspond with the coloured markings identifying the 
terminals in your plug, proceed as follows:

The wire which is coloured BLUE must be connected to the 
terminal in the plug which is marked with the letter N or 
coloured BLACK.

The wire which is coloured BROWN must be connected to the 
terminal in the plug which is marked with the letter L or coloured 
RED.

Under no circumstances should either of these wires be 
connected to the earth terminal of the three pin plug, marked 
with the letter E or the Earth Symbol.

remove the Connector Cover as follows.

1. Remove the Fuse Cover with a screwdriver.

2. Replace the fuse and attach the Fuse cover.

Blue

Neutral

Brown

Live