WV-BF300, WV-BF320 - Panasonic Video Monitoring Service Manual (repair manual). Page 2

WV-BF300/ WV-BF320

This service information is designed for experienced repair technicians only and is not designed for use by the
general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to
service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any
attempt to service or repair the product or products dealt with in this service information by anyone else could
result in serious injury or death.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, 
DO NOT REMOVE COVER (OR BACK). NO USER 
SERVICEABLE PARTS INSIDE.
REFER SERVICEING TO QUALIFIED SERVICE
PERSONNEL.

This  symbol  warns  the  user  that  uninsuland  voltage 
within the  unit  may  have  sufficient  magnitude  to  cause   
electric shock. Therefore,  it  is dangerous to make any kind of 
contact with any inside part of this unit.

This symbol alerts the user that impotant literature concerning 
the operation and maintenance of this has been included.
Therefore,  it  should  be  read  carefully  in  order  to avoid 
any problems.

T

here are special components used in this equipment which are important for safety. These parts are indicated 

by the    mark  on  the  schematic diagram and  the replacement parts list. It is essential that these critical 

parts should be replaced with manufacturer's specified parts to prevent X-radiation, shock, fire, or other hazards.

Do not modify the original design without permission of manufacture.

AC Adapter
Input:

230 V AC, 50 Hz

Output:

6 V DC, 0.2 A, 1.2 VA

Weights and dimensions indicated are approximate.
Specifications are subject to change without notice.

Note: Noise may appear in the monitor images when the camera is used

under high-temperature and low-light conditions.

WV-BF300

1. Determine the place on the wall where you want to install the camera.

Then make a hole (approx. f15 mm) in the wall referring to the diagram
above.

To make a hole for the cables in the wall where the camera is to be installed,
proceed as follows:

WV-BF300

AC Adapter
Input:

230 V AC 50 Hz

Output:

6 V DC, 0.2 A, 1.2 VA

Weights and dimensions indicated are approximate.
Specifications are subject to change without notice.

Note: Noise may appear in the monitor images when the camera is used

under high-temperature and low-light conditions.

WV-BF320

WV-BF320

80 mm (3-1/8”)

80 mm (3-1/8”)

15 mm (9/16”)

Arrow Mark for
upright positioning
of image

1. Determine the place on the ceiling where you want to install the camera.

Then make a hole (approx. f15 mm) in the ceiling referring to the dia-
gram at right.

To make a hole for the cables in the ceiling where the camera is to be
installed, proceed as follows:

15mm (9/16”)

50mm (2”)