BM-ET300A, BM-ET300AE - Panasonic Video Monitoring Service Manual (repair manual). Page 7

– 1-3 –

●

q

@1

w
e
r
t
y
u
i
o

!0

!6
!7
!8
!9
@0

!1
!2
!3
!4
!5

Not in use

Note: Do not connect any cables

to connectors "Not in use".
It may cause malfunction.

Not in use

Not in use

Pin No.

q

Supplies power to a card reader.

w

This is the ground terminal for the power supply and
communication between the iris camera and a card
reader.

e

A signal (DATA0) is input from a card reader to this ter-
minal.

r

A signal (DATA1) is input from a card reader to this ter-
minal.

y

The iris camera works even when nothing is connected
to this terminal.

u

This is the ground terminal for communication between
the iris camera and an access control panel.

i

A signal (DATA0) is output from this terminal to an
access control panel.

o

A signal (DATA1) is output from this terminal to an
access control panel.

!6

This terminal is activated when recognition is success-
fully completed.

!7

This terminal is activated when recognition is not suc-
cessfully completed.

!8

This terminal is closed and low when power is supplied
from an external power-supply device to the iris cam-
era. The terminal is opened when the power supply is
shut down.

!9

This terminal is activated when the iris camera enters
the "tamper detection" mode by the front/rear tamper
detection switch (activated until the "tamper detection"
mode is cancelled).

@0

This is the common terminal for the alarm output con-
nectors.

@1

12 V DC (+12 V at the left/GND at the right) or 24 V AC