SB-VK950GC1, SB-VK950GC - Panasonic Audio Service Manual (repair manual). Page 8

Read Panasonic SB-VK950GC1 / SB-VK950GC Service Manual online

     ·    Be sure to connect speaker cables before connecting the
AC power supply cord.
     ·    The load impedance of any speaker used with this unit must
be High 3
Ω/Low 6 Ω.
     ·    Be sure to connect the cable from the right speaker to the
right terminal and the cable from the left speaker to the left
terminal.
 1. Twist and pull off the vinyl tip of the speaker cords. If the
speaker cords do not have vinyl tips, connect them directly
to the terminals. Make sure the bare ends of the wires are
not unravelled.
 2. Insert the wire to the rear panel of the unit and close the
lever.
Notes :
     ·    To prevent damage to circuitry, never short-circuit positive
(+) and negative (-) speaker wires.
     ·    Be sure to connect only positive (red) wires to positive (+)
terminals and negative (black) wires to negative (-)
terminals.
Positioning
Connection
Positioning for best effect
How to set up your speakers can affect the bass and the sound
field. Note the following points.
     ·    Place speakers on flat secure bases.
     ·    Placing speakers too close to floors, walls, and corners can
result in excessive bass. Cover walls and windows with a
thick curtain.
     ·    Keep your speakers at least 10 mm away from the system
for proper ventilation.
     ·    The angles in the diagrams are approximate.
Use only the supplied speakers
     ·    Using other speakers can damage the unit and sound
quality will be negatively affected.
     ·    Set the speakers up on an even surface to prevent them
from falling. Take proper precautions to prevent the
speakers from falling if you cannot set them up on an even
surface.
Place the front center, and surround speakers at approximately
the same distance from the seating position.
Front speakers
Speakers are designed identically so that no left or right
channel orientation is necessary.
Center speaker
Do not place the center speaker directly on the television as
vibration may cause it to fall or disrupt the picture.
Place it on a rack shelf.
Surround speakers
Place on the side of or slightly behind the seating area, higher
than level.
Subwoofer(s)
2 Connection of the Speaker Cables
8
SB-VK950GC1
Page of 13
Display

Click on the first or last page to see other SB-VK950GC1 / SB-VK950GC service manuals if exist.