Read Panasonic SA-BT230EB / SA-BT230EE / SA-BT230EG / SA-BT230EP / SA-BT330EB / SA-BT330EG / SA-BT330EP / SC-BT230EE Service Manual online
14
4 Specifications
Main unit SA-BT230EB/EG/EP/EE, SA-BT330EB/EG/EP
O
GENERAL
Power supply:
AC 220 V to 240 V, 50 Hz
iPod/iPhone Connector:
DC OUT 5V 500mA MAX
WIRELESS LAN Connector:
DC OUT 5V 500mA MAX
(USB 2.0 Standard)
Power consumption:
Power consumption:
100 W
Power consumption in standby mode:
0.2 W (BT330)
0.1 W (BT230)
Dimensions (W
×
H
×
D):
430 mm
×
54 mm
×
287 mm
Mass (Weight):
Approx. 3.1 kg
Operating temperature range:
0
°
C to 40
°
C
Operating humidity range:
35 % to 80 % RH
(no condensation)
O
AMPLIFIER SECTION
RMS TTL Power Output:
1000 W
1 kHz, 10 % total harmonic distortion
Front:
125 W per ch (3
Ω
)
Center:
250 W per ch (6
Ω
)
Surround:
125 W per ch (3
Ω
)
100 Hz, 10 % total harmonic distortion
Subwoofer:
250 W per ch (6
Ω
)
DIN TTL Power Output:
590 W
120 Hz to 20 kHz, 1.0 % total harmonic distortion
Front:
90 W per ch (3
Ω
)
Center:
115 W per ch (6
Ω
)
Surround:
90 W per ch (3
Ω
)
100 Hz, 1.0 % total harmonic distortion
Subwoofer:
115 W per ch (6
Ω
)
Audio input
AUX
x1
Digital audio input
Optical:
x2
Sampling frequency:
32 kHz, 44.1 kHz, 48 kHz
Audio Format:
PCM, Dolby Digital
O
FM TUNER SECTION
Present Memory:
30 Stations
Frequency range:
87.50 MHz to 108.00 MHz (50 kHz step)
Antenna terminals:
75
Ω
(unbalanced)
O
VIDEO SECTION
Signal system:
PAL 625/50, PAL 525/60,
NTSC
Video output
Output level:
1.0 Vp-p (75
Ω
)
Output connector:
Pin jack (1 system)
HDMI AV output
Output format:
480p(525p)/ 1080i(1125i)/ 720p(750p)/ 1080p(1125p)
Output connector:
Type A (19 pin)
HDMI (V.1.4, Content Type)
This unit supports “HDAVI Control 5” function.
LASER Specification
Class I LASER Product
Wave length:
Wave length:
790 nm (CDs)/650 nm (DVDs)/405 nm (BDs)
Laser power:
No hazardous radiation is emitted with the safety protection
TERMINAL SECTION
USB:
USB:
(Front)
USB Port Power:
USB Port Power:
Max 500 mA
Bit Rate:
Up to 4Mbps (DivX)
(Rear)
USB 2.0 (Uses for Wireless LAN Adaptor only)
Ethernet:
10BASE-T/100BASE-TX
1 system
SD card slot:
Connector : 1 system
Calibration Mic (BT330):
Sensitivity:
Sensitivity:
100 mV, 4.7 k
Ω
Terminal:
Mono, 3.5 mm
Note:
1.
Specifications are subject to change without notice.
Mass and dimensions are approximate.
Mass and dimensions are approximate.
2.
Total harmonic distortion is measured by the digital spectrum
analyzer.
analyzer.
Solder:
This model uses lead free solder (PbF).
Refer to their respective original service manuals for *1.
Click on the first or last page to see other SA-BT230EB / SA-BT230EE / SA-BT230EG / SA-BT230EP / SA-BT330EB / SA-BT330EG / SA-BT330EP / SC-BT230EE service manuals if exist.